WAITIEE WX5 5-in-1 Wireless Charger User Manual
- June 2, 2024
- WAITIEE
Table of Contents
WAITIEE WX5 5-in-1 Wireless Charger
Product Frame
-
A: 15W Output,
Place the Phone which supports wireless charging. (For example, iPhone 12-281 SmAh takes about 3.5hrs to fully charge; iPhone XS Max-3174mAh takes about 4hrs to fully charge. The charging time varies according to the size of the Phone’s battery) -
B: 10 w Output,
Place the Phone or the Earbuds’ Charging Case which supports wireless charging. -
C:5W Output,
Place the Smart Watch which supports wireless charging.(Compatible with apple watch series from S1 to S8 )(usually takes 3-4hrs to finish charge) -
D:2A Output,
connect with a table lamp, usb c cable, usb a cable etc,for any cellphone or other devices which support USB charging. -
E:Charge your the Airpods directly.
-
F:Store Apple Pen.
How to Use
- Let the wireless charger pad connect with the charger which is included in the package. you will notice the phones’ working light flashes green light 3 times.
- Then you can put the devices that you want to charge.
Lights notice:
-
when the usb output is working, Under normal circumstances the usb light will be on blue. If the blue light flashes quickly, it shows the USB cable doesn’t connect correctly, please plug out, then plug in again.
-
When the earbuds’ case .are charged, Under normal circumstances the earbuds light is on blue, too, once the earbuds’ case is fully charged, the blue light will disappear.
If the blue light flashes quickly, it shows the earbuds’ case doesn’t connect correctly, please plug out, then plug in again. -
When the phone is placed on the 15w to charge, Under normal circumstances the green light will flash breathing light, if the green light flashes quickly, it shows the phone is not charged correctly, please place them correctly.(Of course, The phone must support wireless charging)
*Our charger allows the five functions of wireless charging (A.B.C.D.E) to work simultaneously. If you use your own charger, but the operating power is not up to 65w, then can’t work at the same time. (For example 9v 2A, You can only use either one of the 5 functions .A/B/C/D/E)
- Make sure your devices put on the right place of charging areas.
- Make sure the wireless charger is powered by a qualified AC adaptor of 65w.
- If the wireless charging pad doesn’t work just unplug the adaptor and reconnect it.
Any problem please find
Email:amzsmtaftersale@gmail.com
Web:amzsmt.com
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part15 of the FCC Rules.
Operation is subject to the following two conditions:
- (this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.