BAYCO SL-1514 2-Pack 20-Watt LED Magnetic Stand Area Work Lights Instruction Manual
- June 3, 2024
- bayco
Table of Contents
Innovation Made Better™
Instruction Manual
SL-1514
SL-1514 2-Pack 20-Watt LED Magnetic Stand Area Work Lights
THANK YOU FOR PURCHASING THE SL-1514 LED WORK LIGHT.
SAVE THESE INSTRUCTIONS.
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR WORK LIGHT.
WARNINGS
IMPORTANT SAFETY INSTRUCTIONS
WARNING: READ ALL INSTRUCTIONS CAREFULLY
SAVE THESE INSTRUCTIONS
WARNING: When using outdoor lights, basic safety precautions should
always be followed to reduce the risk of fi re, electrical shock, and personal
injury, including the following:
- Not intended for use in wet areas.
- DO NOT use with extension cord near water or where water may accumulate.
- Keep plugs and receptacles dry.
- For use only on GFCI protected circuits.
- Use only three-wire outdoor extension cords 16 AWG or larger that have three-prong grounding plug and receptacles that accept the appliance’s plug.
- DO NOT use this work light with a 2 wire extension cord
- Use only three-wire extension cords rated for outdoor use, such as an extension cord of cord type SEW, SEOW, SEEOW, SEOOW, SOW, SOOW, STW, STW, STOW, STOW, STOOW, SJEW, SJEOW, SJW, SJW, SJOW, SJOOW, SJTW, SJTOW, OR SJTOOW.
SAVE THESE INSTRUCTIONS
SAFETY INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, (EXPOSURE TO
EXCESSIVE UV RADIATION,) OR INJURY TO PERSONS
WARNING: To reduce the risk of FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS:
- Lighted lamp may become hot!
- Light can be used indoor and outdoor.
- Check that the sealed push button switch is in the off position before plugging in the work light
- Connect light to 120Volt, 60 Hz power source only.
- Do not touch hot lens, or enclosure.
- Do not remain in light if skin feels warm.
- Do not look directly at lighted lamp, or direct the light at other persons.
- Keep lamp away from fl ammable materials.
- Use this light only when attached securely to a metal surface capable of supporting the product’s weight.
- Do not use the magnet as a fl oor stand.
OPERATION
CAUTION: BECAUSE THE SL-1514 HAS A MAGNETIC BASE, IT IS LIKELY THAT IT
WILL BE PLACED IN AN ELEVATED POSITION ABOVE THE GROUND. THEREFORE CAUTION
SHOULD BE USED TO BE CERTAIN THAT THE MAGNET IS SECURELY ATTACHED TO THE METAL
SURFACE BEFORE RELEASING THE LIGHT. IT IS ALSO ADVISED THAT EXTRA CARE BE
TAKEN WHEN ADJUSTING OR MOVING THE CORD SO THAT THE WORK LIGHT DOES NOT COME
LOOSE AND FALL TO THE GROUND.
The SL-1514 has a single sealed push button switch located on the back of the
light head.
Turning the light on:
• Press and release the button.
Turning the light off:
• Press and release the button.
WARRANTY
1 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in
workmanship and materials to the original purchaser for 1 year from the date
of purchase, and includes the LEDs, housing, lenses, electronics, switches,
rechargeable batteries and chargers. Bulbs (other than LEDs) are covered for
90 days from the date of purchase.
We will repair or replace this product should we determine it to be defective.
This is the only warranty, expressed or implied, including any warranty of
merchantability or fi tness for a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco-
product-support/warranties.
Retain your receipt for proof of purchase.
Bayco Products, Inc.
• 640 South Sanden Blvd.
• Wylie, TX 75098
• 1-800-233-2155
• 1-469-326-9400
• www.mybayco.com
INS-SL-1514-19
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>