690030 PIR Switch Instruction Manual
- June 3, 2024
- ITC
Table of Contents
690030 PIR Switch
PARTS/TOOLS NEEDED
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive (+) input.
-
Determine the installation location per viewing angle and distance. Drill a 1/2” hole for the wiring. Drill pilot holes sized for the M3 mounting screws provided.
-
Feed the wires through the hole and connect per diagram below. Screw the switch in place.
-
Snap the decorative bezel (optional) in place.
-
Follow the wiring diagram below to wire the switch to your system. Note that the product is internally fused for a max current of 1A. If greater than 1A is detected the unit will shut down and power will need to be cycled to reset the unit.
- OPERATION: The PIR switch will turn on the lights when it senses motion and will turn off after three minutes if no motion is detected. The switch has a range of 120° and a distance of 3’ from the center of the sensor.
3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355 itc- us.com
For warranty information please visit www.itc-us.com/warranty-return-
policy
DOC #: 710-00178 • Rev B • 07/27/22
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>