ITC 69240NS-15-3K-D Hardtop Light Installation Guide
- June 3, 2024
- ITC
Table of Contents
Hardtop Light
Part#: 69670B-XX-KKKK
INSTALLATION INSTRUCTIONS
PARTS/TOOLS NEEDED:
| | | | | |
Hardtop Light| Decorative Bezel| Mounting Screws| 2” Hole Saw Bit
(not provided)| Butt Splice Connectors
(not provided)| Power Drill
(not provided)
IMPORTANT SAFETY INSTRUCTIONS.
READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Determine the installation location for your light. Once determined drill a 2” hole using a hole saw. *Optional, predrill screw holes
- A. Feed wires back through the hole and screw the light in place using the screws provided.
*Follow wiring diagram below before screwing light in place - Attach the bezel by lining up the cutouts and rotating until it snaps in place.
Bi or Tri Color Wiring Diagram
2B. Wire the light following the wiring diagrams below. The color sequence of
the Tri color light will be as follows: 3000K → Off → 4000K → Off → 6500K OR
Red → Off → Blue → Off → 6500K | The color sequence of the Bi color light will
be as follows: 3000K → Off → 6500K. If the light is off for more than 30
seconds it will re-start the cycle.
VersiColor RGBW Wiring Diagram
2B. Wire the light following the wiring diagrams below.
*It is highly recommended that appropriate fusing be used.
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-
policy
DOC #: 710-00091 • Rev B • 11/18/19
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>