BRONCO6G MUD Flaps for Bronoc Instruction Manual
- June 4, 2024
- BRONCO6G
Table of Contents
BRONCO6G MUD Flaps for Bronoc
WHAT IN THE BOX
INSTALLATION INSTRUCTIONS
The Installation Steps of The Mud Flaps Are as Follows:
- Turn the three buckles indicated by the arrow and pull out the wheel brows
- Remove all expansion screws from marked positions.
- Take out the accessories and install as shown in the picture.
- Take out the attachment and align the attachment hole in the previous step as shown in the picture.
- Align the inner lining holes of the original car with the holes of all accessories and install the screws as shown in the picture
- Take out the fender and install it according to the fitting hole, pay attention to the mark on the back of the bracket.
- After all the holes are aligned, fix them using the accessory screws and tools as shown in the picture.
- Remove expansion screws using the original vehicle and fix them 1n the marked pos1t1on.
- Install the original wheel eyebrows and the installation is complete.
- The rear wheel Mud Flaps installation takes the left rear wheel as an example, first find the left rear front tow hook.
- Use a tool to remove the front tow hook screw and remove the front tow hook.
- The disassembly is completed as shown in the figure and then proceed to the next step.
- Take out the two accessory brackets for your fingers as shown in the picture for the accessories used to install the Mud Flaps on the left rear wheel.
- Assemble the two brackets using the accessory screws.
- Place the assembled bracket in the position where the front tow hook was removed.
- Then put the front tow hook on the bottom and fix 11.
- The installation effect of the lower bracket part is completed as shown in the figure.
- Use the tool to remove the screw at the liner pos1t1on as shown 1n the figure.
- Insert the liner edge using the accessory bracket shown and secure with the accessory screws.
- Then use the original car screws to fix the iii liner and bracket.
- After the upper and lower brackets are installed, take out the left rear wheel Mud Flaps and insert it between the original car and the lower bracket.
- The effect after fully inserted is as shown in the figure.
- Note that the upper bracket is aligned with rill the hole in the Mud Flaps.
- Note that the lower brackets line up with the two holes in the Mud Flaps.
- Secure Brackets and Mud Flaps with Accessory Screws and Nuts.
- When fixing, pay attention to pressing the nut on the back.
- The fixing effect of the upper bracket and Mud Flaps is shown in the figure.
- After everything is fixed, use the accessory “L-shaped screwdriver” to fix the lower bracket and Mud Flaps.
- Re-fix the upper bracket and Mud Flaps.
- connection complete effect.
- Reinstall the original wheel eyebrows, the installation is complete.
- You can install the accessory shock-absorbing cotton according to your own needs, draw the outline with a pen from the back for cutting, drill holes with screws, and then tear off the back glue to install.
- The accessory shock-absorbing cotton can effectively fill the installation gap between the original car and the Mud Flaps, preventing noise and wear.
Read User Manual Online (PDF format)
Loading......