REMINGTON XR1750 X5 Limitless Rotary Shaver User Manual

REMINGTON XR1750 X5 Limitless Rotary Shaver

Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.

IMPORTANT SAFEGUARDS

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.

Suitable for use in a bath or shower.

•  Do not use the product with a damaged cord.
• The battery in this device is not replaceable.
• Do not use the appliance if it is damaged or malfunctions.
• Do not use attachments other than those we supply.
• This appliance should never be left unattended when plugged into a power outlet, except when charging.
• Keep the power plug and cord away from heated surfaces.
•  Do not plug or unplug the appliance with wet hands.
•  Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.

PARTS

1. On/off switch

2. Pivoting head and cutter assembly

3.  Individual flexing heads

4. Hairpocket

5. Charging indicator lights

6. Detail trimmer

7. Head release button

8. Power connector
   Not shown

   • USB charging cable
   • Cleaning brush
   • Head guard

CHARGING

•  It is recommended to fully charge your product before using for the first time.
• Ensure the product is switched off.
• Connect the product to the USB cable and then to the USB end of the cable to a powered USB port.

CHARGING INDICATOR LIGHTS

• The red light will flash slowly when your shaver is charging.
• When charging is complete, the red light will go out and the green light will come on for 5 seconds.
• If your shaver does not run when you switch it on, and the red light slowly flashes for 5 seconds, your shaver needs charging.
• Run time from fully charged is up to 50 mins.
• Charge time from empty is 90 mins.
• Do not recharge your product after each use as this will shorten the life of the battery.
• Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.

QUICK CHARGE FEATURE

Your shaver has a 5 minute quick charge feature that will provide enough charge for 1 shave (3 minutes).

INSTRUCTIONS FOR USE

SHAVING

1. Switch the shaver on by pressing the on/off button.
2.  Stretch the skin with your free hand so the hairs stand upright.
3. Only apply light pressure on the shaving head while shaving (pressing too hard can cause skin irritation).
4. Use short, circular strokes.

SHAVING WITH SHAVING GEL

•  Follow the same instructions as dry shaving if using shaving gel.
• CAUTION After use with shaving gel, please rinse the head and cutters under warm water to clean away any excess gel and debris.

DETAIL TRIMMER ATTACHMENT

To fit the detail trimmer attachment:

1. Switch off your shaver.
2. Pull the head and cutter assembly away from the body of your shaver (Fig A).
3. Clip the detail trimmer onto the body of your shaver (Fig. B).

TIPS FOR BEST RESULTS

• Always hold the shaver at right angles to the skin so that all three heads are touching the skin with equal pressure.
• Use moderate to slow stroking movements. The use of short circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid skin irritation.

CARE FOR YOUR SHAVER

Care for your appliance to ensure a long lasting performance. We recommend you clean your appliance after each use.

1. Open the shaver head by pressing the release button (Fig. C).
2. The head assembly will open (Fig. D).
3. Rinse under a tap to wash away hair trimmings.
4. Carefully brush away any hairs from the cutters.
5. Close the head assembly.

Note: The individual cutters are designed to be permanently retained in the shave head and flushed out with water. Do not remove the individual cutters for cleaning.

DETAIL TRIMMER

Lubricate the teeth of the detail trimmer every six months with a drop of sewing machine oil.

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of the shaver case, and tools have sharp edges and may cause injury if not handled correctly.

• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
  1.  Remove the shaver head (pull the head up and off).
  2.  Using a small screwdriver, pry the front panel off the handle.
  3. Unscrew the 3 screws located on front of shaver.
  4. Using a small flat screwdriver, pry the front housing from the body.
  5. Unscrew the 6 screws to open the inner housing.
  6. Take out the circuit board.
  7. Disconnect the battery from the circuit board.
• The battery must be disposed of at an appropriate official recycling/collection point.
• Do not attempt to operate the shaver once you have opened it.

RECYCLING

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.

References

• Remington - EST. NEW YORK 1937 | Haircare & Personal Care Appliances for Men & Women

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>