akyga AK-ND-48 Power Supply User Manual
- June 3, 2024
- akyga
Table of Contents
notebook power supplies
AK-ND-68 – user manual
Short description of the product
The Akyga AK-ND-48 power supply is used to deliver power to a notebook with
direct current.
The 40W power supply is compatible with all 19V/2.1A nootebooks models with
5.5×3.0mm + pin plug.
A set of protectors OVP, OTP, OPP, SCP, OCP and the soft start technology
provides safe and stable work of both power supply and powered device.
The product is adapted to supply voltage in the range of 100-240V, 50/60Hz.
The power consumption of powering nootebook can not exceed the power supply
nominal current.
The product is compatible with the applicable national and European
requirements.
What is in the box?
- AK-ND-48 power supply
- Short user manual
Symbols explanation:
There is a particular danger connected with service.
There is a risk of losing health or life (e.g. by electic shock).
Important tips and information.
The CE standard description on the product is the manufacturer’s
declaration that the marked product meets the requirements of the directive
so-called The “New pproach” of the European Union (EU). For security and
certification (CE) reasons, the device can not be rebuild or change in any
way. In the reason of using the power supply for ther purposes than those
described, the product may be demaged. The incorrect use may also cause hazard
such as short-circuits, burns, electric shocks, etc. Read the users manual
carefully and keep it for later use. The product could be share to third
partie only with the user manual included.
Product accordance with the EU directive 2002/96/EC. The symbol of the crossed
out basket placed on the product means that the marked product can not be
disposed of with other household waste. After use, the product must be return
to collection point for used electical and electronic equipment or to the
seller. Appropriate segregation of rubbish for subsequent processing, recovery
or descrution contributes to avoiding negative effects on the environment and
health, and also allows the recovery of raw materials from which the product
is made.
The RoHS mark on the product is the manufacturer’s declaration that the marked
product meets the requirements of the EU Restriction of Hazardous Substances
2002/95/EC) directive, which aims to reduce the amount of hazardous substances
penetrating into the environment from electrical and electronic waste.
The II protection class device. It provides protection against electric shock
against direct and indirect contact, and thanks to the additional isolation it
is not necessary to connect the device case with the protective earth
conductor.
The device is intended only for domestic use, indoors.
Safety Precautions
WARNING! Product heats up during operation. To reduce the risk of burns
or overheating the power supply, do not place it in restricted ventilation
area. Also, do not allow he working power supply to touch soft surface such
as pillows, blankets or clothing. The power supply meets the limits on the
surface temperatures available to the user, as defined in the International
Standard for Safety of Information Technology Equipment (IEC 60950).
Connecting notebook whose demanded power is greather than power of the power
supply, can cause battery failure or even damage (burn) of power supply.
An electrostatic discharge occurs when two object touch each other, for
example, an electric charge that occurs when user touch metal door handle
after walking on a carpet . Discharging electrostatic charges from fingers or
other electrostatic conductors can damage electronic components. To avoid
damaging the computer, abstain from touching electrical outlets, wires and
electonic circuits. The user’s contact with electronic components should be
kept to a minimum.
The manufacturer of the product is not responsible for damage or insults
caused in effect of disobey the safety instructions and informations contained
in these user manual.
- Keep the product and the packaging out of range of children and animals. The package includes a foil that child could choke while playing.
- It is forbidden to apply the mechanical load to the product – strong shocks, impacts, dropping or crushing may cause its damage.
- The product operation in adverse conditions is not allowed. Adverse conditions are primarily: exposure to direct sunlight, high or very low ambient temperatures, strong vibrations, high humidity, surrounds of gases, dusts or flammable and aggressive liquids.
- If the product has been damaged, does not work properly or has been stored for a long period of time in bad or unfavorable conditions, safe operation of the device is not possible. It is essential to stop using the product and to protect it against re-use for security purposes.
- Product and power cord should not be touched with moist or wet hands under no circumstances.
- Short-circuiting the current connection is prohibited.
- Make sure that the power cord is not crushed, bent, twisted, rubbed against sharp edges or mechanically loaded in any other way. Avoid thermal load of the cable – in particular keep away from heat sources (such as stoves, radiators, fireplaces).
- Power cords should be laid in such a way as to eliminate the risk of stumbling or hooking over.
- Its forbidden to modify the power cord. In the case of modifications, the cable may be damaged, causing threats to life, health and property.
- Connection of the power supply to electricity is done by connecting cable with the IEC C6 plug to power supply with IEC C5 connector and then connecting appropriate plug to grounded electrical outlet.
- Before connecting the adapter to the mains socket, make sure that the voltage specified on the power supply matches voltage supplied to the household socket.
- **** Mains plug should be disconnect from power socket if the product is not in use for a long time.
- When disconnecting the power cord from the socket and from the device, do not pull on the cord, but only on the part of the cable plug provided for this purpose.
- In case of any doubts regarding operation, safety or connection of the product, please contact the manufacturer or a qualified specialist for this purpose.
- All maintenance, adjustment and repair work on the product may only be carried out by a qualified person in a specialist facility.
Removing the most common problems
Problem | Cause | Solution |
---|
A laptop connected to an electrical outlet via
power supply does not work| No mains voltage| •Check the correct connection of
the power supply to the mains socket
•Check the mains fuses
The power supply is overloaded| •Disconnect the power supply from the laptop,
check the correctness of the current parameters
There is a suspicion of a product defect| •Stop using and contact the seller
A laptop connected to an electrical outlet via
power adapter does not charge the battery or displays a message about the non-
genuine charger| The power supply does not correspond to the current
parameters| •Disconnect the power supply from laptop and check if current
parameters are correct
•Contact with seller
Preparing the Power Supply for Use:
- Select and connect the appropriate connector to power supply.
- Connect power cord to the electrical socket.
- Connect the power supply connector to the nootebook.
- Turn on the notebook.
Cleaning the power supply
**** Disconect the power supply from the electrical socket and connected
devices before cleaning.
- Use soft and antistatic cloth for cleaning the power supply.
- Do not use abrasive or chemical cleaners.
Technical specfication
Product code: | AK-ND-48 |
---|---|
Supply voltage: | 100-240V , 50/60Hz |
Output voltage and amperage: | 19V / 2.1A |
Maximum power: | 40W |
Efficiency: | >80% |
OVP (over voltage protection) : | Yes |
OCP (over current protection) : | Yes |
OPP (overpower protection) : | Yes |
OTP (over temperaturre protection) : | Yes |
SCP (short circuit protection) : | Yes |
Soft start: | Yes |
Power inlet: | IEC C8 |
Output connector: | 5.5×3.0 mm + pin |
Compilance with standards: | CE, FCC, RoHS |
EAN code : | 5.90172E+12 |
Connector polarity diagram: |
Product manufacturer:
Akyga Europe sp. z o.o.
ul. Wrocławska 1c 52-200 Suchy Dwór http://www.akyga.com/en/ak-nd-48.html
Documents / Resources
|
akyga AK-ND-48 Power
Supply
[pdf] User Manual
AK-ND-48 Power Supply, AK-ND-48, Power Supply
---|---