phocos Pytes Inverter User Guide
- June 3, 2024
- phocos
Table of Contents
phocos Pytes Inverter
Connect the cables and set the DIP Switch
Connect the power cables between inverter and battery or the Busbars.
A custom ethernet cable is needed for the communication between Pytes E-BOX
battery and Phocos Any-Grid™ series.
Figure 2.1.2.1 Pin assignment of Phocos Any-Grid™ series inverter
| Pin | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
|---|---|---|---|---|---|---|---|---|
| Function | RS-485B | RS-485A |
Plug in the battery end into the RS485 port of the Bytes E-BOX battery and
plug in the inverter end into Phocos BMS Port as shown in Figure 2.1.2.4
Program the inverter
- Press for 3 seconds to enter settings mode.
- Press or select between settings menus. Once selected, press to confirm the selection or exit without confirmation.
- Select 05 (Battery type) and set the value to (RS-485) as shown in Figure 2.1.2.5
- Please refer to the Phocos AnyGrid Hybrid inverter manual for more settings such as Grid Setup, PV Setting, etc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>