ITALPROFILI 45 Accessories For Synthetic Pvc-P Membranes Installation Guide
- June 3, 2024
- ITALPROFILI
Table of Contents
ITALPROFILI 45 Accessories For Synthetic Pvc-P Membranes
INSTALLATION
- Apply a layer of primer to the substrate around the area of the drain pipe (approx 600×600 mm), use the quantities indicated by the producer.
- Torch apply the first layer of waterproofing membrane and cut out the area in correspondence to the drain pipe.
- Make sure that there is at least a 3° slope. Insert the drain into the hole and mark the length for cutting. If the drain should be used together with a curved pipe fitting, Art. 46 – 47, the drain should be cut making sure that the lower part is 5 mm longer than the top. If the drain is used with Art. 118, the pipe must be cut at a 45° angle (see Fig. A).
- Heat the previously area of the first layer of waterproofing membrane in correspondence to the hole and press the flange into position.
- Heat a piece of membrane and spread the melted compound with a trowel in order to cover the ribbed and slotted surface of the flange.
- Install the second layer of membrane by heating both the previously spread compound as well as the second waterproofing layer and press down strongly.
- Before installing the curve fitting, apply a bead of sealant, make sure that the fitting fits correctly into the tabs of the curve.
- Insert the leaf or gravel grate, Art. 44.1.
DESCRIPTION FOR SPECIFICATIONS
Supply and installation of ITALPROFILI® 90° angled drain unit or similar, made from flexible synthetic rubber IGOM.EE.
Dimensions: 500 mm long stem, 65 mm in height by 100 mm in width with a flexible flange, complete with 65×100 mm curve fitting with a Ø of 80 or 100 mm for connecting downspout or hopper, with leaf or gravel grate.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>