STNTUS innovations BVP130 Electrical Vacuum Pump User Manual

STNTUS innovations BVP130 Electrical Vacuum Pump

SAFETY INSTRUCTIONS AND EXPLANATION OF OPERATION

OPERATING CONDITIONS
The maximum surrounding temperature for normal use is +40°C, while the average temperature during a 24-hour period must not exceed +35 °C. The lowest allowed surrounding temperature is -5 °C. Normal room temperature is most suitable. Surrounding air must be clean, relative humidity must not exceed 50 % at the maximum temperature of +40 °C. The higher relative humidity is allowed with lower surrounding temperature (e.g. 90 % at +20°C).

SAFETY INSTRUCTIONS

• Choose the place for the device carefully. The surface used for the device must be dry and of normal temperature (not hot), and must not be next to a heat source (heating surface) or source of water.
•  Check the USB charging cable, connectors, and adapter (which can be bought additionally), and plug before connecting the device to the adapter and the adapter to the plug (power supply). If you observe any defect, contact our repair service listed below.
•  Use the device exclusively for the purposes described in the instructions for use.
•  If the USB charging cable is damaged, the manufacturer authorized repair service, or similarly, qualified personnel must replace it to prevent any danger.
• This device can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the device. Cleaning and user maintenance shall not be made by children without supervision.
• The warranty is void in the following cases:
  •  An unauthorized or unqualified person attempts to repair the device.
  •  The device is used for purposes other than intended.
  •  Safety rules and instructions for use are not followed.
•  Never use the device in an explosive atmosphere.

Store the device in dry spaces at room temperature. When correctly connected and used in accordance with the instructions, the device is not dangerous. Electrical components use low voltage and are protected against dust. Read the instructions for use thoroughly before use. The instructions for use should be stored next to the device and always available during use. Opening the device and accessing its interior by a user is forbidden. The manufacturer assumes no liability for damage caused by incorrect use or by failure to comply with the instructions.

MAINTENANCE AND CLEANING

•  Before cleaning, unplug the adapter.
•  Store the USB charging cable and the device in a dry and ventilated place.
•  Use a soft, dry, or slightly damp cloth to clean the device. Do not use sponges, coarse cloth, polishing agents, disinfectants, or aggressive cleaning agents that may damage the surface of the device. Never immerse the device in water or put it under running water. Never spray cleaning agents directly on the inside or outside of the device.
•  The device must be completely dry before use.
•  If liquid enters the interior of the device, consult the seller or authorized repair service.

REPAIR SERVICE

• Only qualified and authorized personnel may perform repairs.
•  Only experts that can assess the task at hand and related risks, based on their technical education and knowledge of appropriate standards, can perform repairs.
•  Troubleshooting is performed by the manufacturer or an authorized representative.
• If possible, components that need to be replaced are replaced with the original or functionally identical spare parts.

GENERAL INFORMATION

The electrical vacuum pump BVP130 is a vacuum packing device. It is intended to be used on Status vacuum containers, jugs, lids, and stoppers thereby creating a vacuum and ensuring quality vacuum storage of food in a container, jug, bottle or jar. The biggest advantages of vacuum storage are the following:

•  it preserves vitamins, minerals, nutrients, and the aroma of foodstuffs,
•  it protects food from the spread of mold and bacteria,
•  it prolongs the shelf life of foodstuffs,
•  food stored in vacuum containers can be refrigerated or frozen,
•  it prevents the unpleasant mixing of odors in a refrigerator and freezer.

The use of the electric vacuum pump is simple and efficient. It allows you to store food in a completely natural and healthier way. Food remains fresh longer and you end up saving time and money. Please read the user manual thoroughly before first use and follow the instructions. Should any questions, opinions, or comments arise, feel free to contact us by phone or mail. This user manual is also available in electronic form at our website www.status- innovations.eu/knowledge-base/user-manuals/.

PRODUCT SPECIFICATION

Dimensions| Width: 55 mm

Length: 55 mm

Height: 112 mm

---|---
Weight| 0.2 kg
Material| PC ABS plastic, silicone
Rated voltage and current| 3,7 V , Li-Ion, 800 mA
Adapter

(not included)

| Input: 100-240 V~, 50-60 Hz

Output: 5 V , 800 mA

COMPONENTS AND DESCRIPTION
OF THE PRODUCT’S FUNCTIONING
The image below shows the BVP130 electric vacuum pump. It is easy to use since all you have to do is place it on top of the silicone valve and press the button.
Lights explanation:

•  The indicator light alternates between red and green flashes during operation.
•  A short flash of the red light signals an empty battery and indicates the pump needs to be charged.
•  The pump is charged when the green light turns on.

The electric vacuum pump creates a preset vacuum pressure in a container, jug, bottle, or jar. The most important functions and components are indicated with numbers.

1. ` Button and color indicator
2.  The body of the vacuum pump
3.  Silicone seal
4.  USB power cable
   •  USB 2.0 and
   • Micro USB
5.  Slot for the micro USB connector

GENERAL INSTRUCTIONS

• Upon removing the electric vacuum pump from its packaging make sure that all the component parts are included and that the device and all its component parts are fully operational. Take special care to remove all the packaging bits from the seal.
• Make sure you read the user manual thoroughly before first using it and following the instructions.
• The electric vacuum pump is designed for household use.

INSTRUCTIONS FOR USE

• The vacuum pump needs to be charged before first use.
• Vacuum pack by placing the vacuum pump on the valve at the center of the lid of a vacuum container, jug, or vacuum stopper and press lightly.
• Press button. The pump automatically sucks the air out of the container, jug, or bottle.
• The indicator light alternates between red and green flashes during vacuum packing.
• The duration of vacuum packing depends on the size of the container and the amount of food: vacuum will be created faster in a smaller container than a larger one, and in a full container than an empty one.
• The pump disengages automatically when the vacuum pressure in a container reaches the preset value.
•  The operation of the pump can be stopped at any time by pressing the button.
• If the pump’s battery is empty, it will not power on upon pressing the button. The battery needs to be charged.

CHARGING

• The electric vacuum pump usually needs to be charged before first use. Insert the smaller USB connector (micro USB) into the port at the top of the pump and the larger USB connector (USB 2.0) into an electric adapter with a USB port.

• The pump can be charged by using an adapter, a portable battery (5 V, in 800 mA), or by plugging it into a USB port (USB 2.0) of a computer or a laptop. In this case, the charging speed depends on the USB port’s use: if the USB port is intended for data transfer only, the battery charging will take longer, and if it is intended for charging electronic devices, the charging will be faster. It usually takes 2 to 4 hours for the pump to be fully charged.

• The indicator light flashes red during the charging of the device. d.) The charging is complete when the indicator light changes from
  red to green.

• To maintain the optimal functioning of the battery, charge it at least once every 3 to 6 months.

DECLARATION OF CONFORMITY

•  Directive on the harmonization of the laws of the Member States relating to the making available on the market of electrical equipment designed for use within certain voltage limits LVD DIRECTIVE 2014/35/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL
•  Directive on the harmonization of the laws of the Member States relating to electromagnetic compatibility (recast)
  EMC DIRECTIVE 2014/30/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL

EU Declaration of conformity guarantees that the machine is safe and has been inspected and tested to meet all the requirements specified in the applicable standards, directives, and regulations. EU Declaration of conformity for CE marking is located at the seller and can be provided per the customer’s request.

TROUBLESHOOTING

the pump’s battery is empty. Charge the battery.
The pump does not create vacuum in a container, jug or in a container closed with a universal lid, or the| • Check if the lid of the vacuum container, the seal, and the valve are positioned correctly.

• Check if the silicone seal and the valve of the container are clean and dry. If necessary, remove the valve from the lid,

vacuum does not

persist.

| clean it, and reattach it.
The pump works but it

does not create vacuum in

a container.

| • During the vacuum packing press the pump in the dock surrounding the valve in order to create a tight seal between the pump and the area around the valve.

• Check if the lid of the vacuum container, the silicone seal and the valve are positi- oned correctly.

• Check if the silicone seal and the valve of the container are clean and dry. If necessary, remove the valve from the lid, clean it, and reattach it.

The problems encountered cannot be solved.| • You must contact the repair service. The manufacturer will assume responsibility only if you comply with instructions and do not attempt to repair the device yourself.

CORRECT DISPOSAL OF YOUR VACUUM MACHINE

When the equipment or parts of the device are no longer fit for use they must be disposed of at the industrial waste landfill in accordance with applicable regulations:

• Directive on waste electrical and electronic equipment (WEEE) DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL
•  Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment

DIRECTIVE 2011/65/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL

Environmentally hazardous components and parts that were built into the device have to be disposed of at specialized sites. The symbol on the product or its packaging indicates that at the end of its life, the product may not be treated as ordinary household waste and must be disposed of in accordance with your local authority’s instructions and at properly designated sites. You can also use an official WEEE collection service provider in accordance with directive 2012/19/EU. Separate collection of individual components of EE equipment prevents negative effects of environmental pollution and minimizes danger to human health, which may occur as a result of improper product disposal. In addition, it enables the reuse and recovery of the material, thus saving energy and raw materials. For detailed information on collecting, sorting, reuse, and recycling of the product contact the provider of WEEE collection services or the shop where you bought the equipment.

WARRANTY

This warranty is valid for two years from the date of purchase. Evidence of original purchase is required for warranty services, so it is important to keep your sales receipt.
This warranty only covers breakdown caused by electrical or mechanical failure. It does not cover damage caused by liquid entering the device or breakdown caused by failure to follow the manufacturer’s instructions. If you have any comments or questions concerning the functioning of the machine or warranty, please contact us: Ulica Belokranjskega odreda 19, 8330 Metlika, Slovenia Customer phone: +386 736 91 230 E-mail: [email protected] For more information visit our website www .status-innovations.eu.

ELECTRIC VACUUM PUMP BVP130 SET

The set includes

•  1 electric vacuum pump BVP130
•  1 charging cable USB 2.0/micro USB
•  1 user manual

References

• Home – Status Innovations - Made in Slovenia, EU - Since 1995

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>