IKEA 505.034.14 DIRIGERA Hub for Smart Products Instruction Manual
- June 3, 2024
- Ikea
Table of Contents
IKEA 505.034.14 DIRIGERA Hub for Smart Products
Getting started
Connect the USB cable to the power supply unit and your hub. Then plug the
power supply unit into the wall socket.If you have an Apple device
Go to the App Store and download the IKEA Home smart app. The app will take
you through the process of installing your hub and other devices.
If you have an Android device
Go to the Google Play store and download the IKEA Home smart app. The app will
take you through the process of installing your hub and other devices.
Your hub’s status lights
Understanding your hub’s status lights
Ring light – loading
Shown when the hub is connected to power and is starting up. Wait for the
light to fill the ring before proceeding with connecting the hub to the app.
Ring light softly pulsing white
This is shown once your hub has finished starting up. You can now follow the
instructions in the app to connect your hub.
Centre light constant white
Shown when the hub is connected to the internet and everything is OK.
Centre light double-blinking white
Shown when the hub is disconnected from the internet. You can continue to
control your devices through the app and your home WiFi network.
Ring light – spinning white
When your hub is updating or busy processing a large amount of information.
Rebooting your hub
Disconnect and reconnect the power to your hub to reboot it. The ring light
fills to symbolise loading while starting up. This will not delete information
on your hub.
Factory resetting
Push a pin into the pinhole on the underside of the hub until the status
lights turn off. The centre light will then blink red 4 times when the hub is
ready. Note – this deletes all previous hub information.
Adding IKEA Home smart to your hub
Follow the instructions in the app to add “Works with IKEA Home smart” devices to the hub.
Care instructions
Unplug the power supply unit from the power source before cleaning and when the hub is not in use. To clean the hub and the power supply unit, wipe with a soft cloth moistened with a small amount of mild cleaning agent. Use another soft, dry cloth to wipe dry. Never submerge the power supply unit or hub in water. Never use abrasive cleaners or chemical solvents as this can damage the products.
IMPORTANT
- The wall socket must be located near the equipment and must be easily accessible.
- Storage temperature: -20 °C to 25 °C (-4°F to 77°F).
- Operating temperature: 0 °C to 40 °C (32ºCF to 104 ºF).
- Do not leave the hub in direct sunlight or near any heat source, as it may overheat.
- Do not subject the hub or power supply unit to wet, damp or excessively dusty environments, as this may cause damage.
- The range between the hub and the receiver is measured in open air.
- Different building materials and placement of the units can affect the wireless connectivity range.
- Children should be supervised to ensure that they do not play with the product.
- This equipment is only suitable for mounting at heights up to 2 m.
- Recommended precautionary measures and technical data, see the back of the power supply unit.
Product servicing
Do not attempt to repair this product yourself. If you open or remove parts,
you may expose yourself to dangerous voltage points or other risks.
Save these instructions for future use.
Technical data
- Model : DIRIGERA hub for smart products
- Type : E2003
- Input : 5.0V DC
- Range : 10 m in open air
| Operating frequency: | Output power: |
|---|---|
| 2400 – 2483.5 MHz | 11.8 dBm |
| 2412 – 2472 MHz | 17.7 dBm |
| 5180 – 5700 MHz | 14.9 dBm |
Power supply unit
- Type : ICPSW5-10NA-1
- Input : 100-240 VAC, 50/60 Hz, 0.3A
- Output : 5.0 V DC
- Max total load : 2.0 A, 10.0W
Indoor use only
Manufacturer :
IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by IKEA is under license. Other trademarks and trade names are those of their respective owners
RF EXPOSURE INFORMATION
According to RF exposure regulations, under normal operations the end user
shall refrain from being closer than 20 cm from the device
- the device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; [Reference: RSS-247 Section 6.4 (5) (i)]
- high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650- 5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. [Reference: RSS-247 Section 6.4 (6)]
This device complies with Part 15 of the FCC Rules. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation Science and Economic Development Canada’s licence-exempt RSS standard(s).
FCC
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the quipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
License rights and limitations
NO RIGHTS OR LICENSES, EXPRESS NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE
GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A
WIRELESS MESH NETWORK, OR TO USE THIRD-PARTY SERVICES TO ACCESS, MONITOR OR
CONTROL THESE PRODUCTS IN A WIRELESS MESH NEWORK VIA THE INTERNET OR ANOTHER
EXTERNAL WIDE AREA NETWORK.
For use pursuant to U.S. Patent Nos.:
US 6,914,893 US 7,697,492 US 8,964,708
DISPOSAL
The crossed-out wheeled bin symbol indicates that the item should be
disposed of separately from household waste. The item should be handed in for
recycling in accordance with local environmental regulations for waste
disposal. By separating a marked item from household waste, you will help
reduce the volume of waste sent to incinerators or land-fill and minimize any
potential negative impact on human health and the environment. For more
information, please contact your IKEA store.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>