ORTEACH SLIM4GIM-5CCT LED Slim Lights Instruction Manual

: June 4, 2024
: ORTEACH

Table of Contents

INSTALLATION GUIDE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ORTEACH SLIM4GIM-5CCT LED Slim Lights Instruction Manual

WARNING

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

LED Slim Lights are suitable for indoor use only. DO NOT use outdoors
Please keep the LED Slim Lights away from any corrosive substance, and please use dry cloth when you clean them
LED Slim Lights can only be installed by a qualified electrician
Before installation or maintenance, please disconnect the power to prevent electric shock

Application Notice

For your safety, this fixture MUST be wired in accordance to local electrical codes and ordinances
Turn power off from the electrical panel before starting installation or attempting any maintenance. Indoor installation only

CAUTION

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.

INSTALLATION GUIDE

Tools Required

Saw
Measuring Tape
Electrical Wiring (use type and gauge suitable for application to connect the fixtures)

Driver Wiring

Open the hardwire box swing cover and remove the appropriate knockout(s)
Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately)
Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box. Connect WHITE wire of cable to WHITE wire of box. Connect BLACK wire of cable to BLACK wire of box (see Fig.1)
lace all wiring and connections back into the box and close the cover
Insert hardwire box through the mounting hole (see Fig.2).

INSTALLATION GUIDE

New Construction Applications:
Hardwire box shall be firmly secured to studs, joists, or similar fixed structural units

Remodel Applications:
DO NOT require the hardwire box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed

Pre-installation

Turn power OFF from the electrical panel before starting installation
Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions
Run electrical wire from the switch (power supply) through the mounting hole — use NMD90 Romex or BX cable

Fixture Installation

Connect the fixture to the hardwire box by inserting and twisting the male / female connectors (see Fig.3)
Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled flush to the ceiling (see Fig.4)
Once assembly is complete, turn ON power to confirm that fixture is working properly.

INSTALLATION GUIDE