FRIGIDAIRE GALLERY GRMC2273CBSS Multi-Door Refrigerator User Guide
- June 3, 2024
- FRIGIDAIRE GALLERY
Table of Contents
FRIGIDAIRE GALLERY GRMC2273CBSS Multi-Door Refrigerator
Before you start
Set up your refrigerator
Remove tape and glue residue from surfaces before turning on the refrigerator.
Choose a place near a grounded electrical outlet, allowing for clearances for
ease of installation, proper circulation, and plumbing and electrical
connections.
Before operating for the first time
After you remove all of the package materials, clean the inside of your
refrigerator before using it. See CARE AND CLEANING in your Use & Care Manual.
You’re in control
Your appliance control display
We recommend you set your temperatures at 37˚F (3°C) for the refrigerator
compartment and 0˚F (-18°C) for the freezer. After 24 hours, you can adjust
the control as desired, allowing the temperature to stabilize. Control display
varies by model. See the Use & Care Manual for more detailed information about
your appliance.
EXTERNAL DISPENSER CONTROL DISPLAY
-
Activate Freeze Boost prior to grocery shopping to lower the temperature and freeze food faster. Freeze Boost remains active
for up to 24 hours. -
Press Cold Drink Timer to start a timer for chilling drinks.
-
The ice maker makes ice until the ice bin is full. Press and hold Ice Maker for 3 seconds to turn it on/off.
-
Press and hold for 3 seconds to enable/disable the appliance control display.
-
Press either + or — to adjust to desired temperature setting inside the refrigerator or freezer compartment. Adjusting Temp
illuminates until you reach the desired temperature(s). -
Power Outage illuminates and alerts sounds after a power outage ends until you reset it by pressing any button.
-
Door Open illuminates and alerts sound if the door is open 5+ minutes until you close the door.
-
°F/°C allows you to switch between Fahrenheit (°F) and Celsius (°C).
-
Replace Water filters or Replace Air Filters illuminates when it’s time to change the filters, generally every 6 months.
-
Prior to grocery shopping, we recommend you activate Chill Boost to cool your food faster.
SIDE DOOR DISPENSER CONTROL DISPLAY
-
Use it to lock the display. Press and hold for 3 seconds to enable/disable. The indicator flashes and an alert sounds when CONTROL LOCK is enabled. You can’t make changes on the display while the lock is engaged.
-
Select the compartment for temperature change (FREEZER or REFRIGERATOR). Press either the + or — to adjust to
desired temperature setting. Freezer temp – Control temperatures range from -6°F / -21°C to +6°F / -15°C. Refrigerator temp Control temperatures range from +34°F / +1°C to +44°F / +7°C. This unit is designed to operate at 37°F Refrigerator/0°F
Freezer. Temperatures should stabilize within 24 hours of installation. -
Clear Alerts resets any alarms that are active and illuminated on the display (Door Open, High Temp, Power Outage).
-
Activate Freeze Boost prior to grocery shopping to lower the temperature and freeze food faster. Freeze Boost remains active for up to 24 hours.
-
°F/°C allows you to switch between Fahrenheit (°F) and Celsius (°C).
-
Press and hold for 3 seconds to enable/disable the water dispenser. When enabled, the LEDs above Water Dispenser illuminate.
-
Press and hold Default Settings for 3 seconds to reset to default settings.
-
Press and hold Water Filter or Air Filters for 3 seconds to reset after replacing the file
Keep it fresh
Frigidaire PureAir®® AF-2™ Replacement Refrigerator Air Filter (1 included)
- Frigidaire PureAir® AF-2™ Replacement Refrigerator Air Filter (1 included)
- More powerful than baking soda, the new PureAir AF-2 Replacement Refrigerator Air Filter absorbs undesirable smells keeping your fridge fresher for up to 6 months.
- The air filter is located at the top center of the refrigerator compartment. To change your filter:
- Remove the air filter cover by squeezing the top and bottom of the cover together and removing it from the liner.
- Remove the old filter and discard it.
- Unpack the new filter and snap it into the filter cover. Install the open face (carbon media) of the filter facing outward in the cover.
- Replace the air filter cover by squeezing the sides and snapping it back into place.
- To reset, after replacing the filter, press and hold Air Filter on the appliance control display for 3 seconds. The status will reset to GOOD.
Frigidaire PurePour Connect™ PWF-2™ Ice & Water Refrigerator Filter (1 installed)
-
Makes safer water second nature – certified to reduce contaminants and keep great-tasting water flowing for you and your family for up to 6 months.
-
The water filter is located at the top right side of the refrigerator compartment.
-
Before dispensing water for the first time, be sure to prime the water supply system
(NOTE: Ensure you enable Water Dispenser on SIDE DOOR DISPENSER models. LEDs above the button are lit.) : -
Hold a glass against the paddle for about 4 minutes to purge air from the system.
-
Continue dispensing at least 1 full gallon (3.6 L) of water and discard.
-
Install your new PureAir PK-2 Produce Keeper Plus™ Refill to extend the life of produce (2 included)
-
Remove the outer plastic wrapper.
-
Insert the unopened packets into the holder in the Crisper, as shown on the left.
FAQs
My refrigerator is making unfamiliar sounds. Is this normal?
Your new, high-efficiency unit may introduce unfamiliar sounds. These sounds
normally indicate your appliance is operating correctly. See the NORMAL
OPERATING SOUNDS section of your Use and Care Manual for more information.
How do I use the side door dispenser?
Your side door dispenser is located in the left-hand refrigerator door. To use
the dispenser simply hold the door with one hand while placing your glass
under the nozzle and pushing the paddle to dispense water with your other
hand. If your glass doesn’t enable the paddle due to size, use your finger to
activate the paddle for dispensing.
Why does my refrigerator seem to run continuously?
Your variable speed compressor is designed to run 100% of the time except
during the defrost cycle. At times it will run faster, such as after a defrost
cycle.
How does my CrispSeal® Fresh Crisper work?
Our crispers block out dry air and slow down the aging process of your produce
by reducing ethylene gases, which cause produce to ripen faster. Good news –
no settings needed! CrispSeal Fresh crispers are equipped with an automatic
humidity control membrane. We do not recommend replacing the auto-humidity
membrane unless it becomes damaged or dirty. If the membrane requires
cleaning, you can simply wash it with soap and water. Make sure you thoroughly
dry the membrane before replacing in your refrigerator. For more information
refer to TROUBLESHOOTING at the back of your Use & Care Manual.
Let’s make it official!
Take the first step to becoming a part of the Frigidaire family and
discover more benefits by registering your multi-door refrigerator.
Look for the PhotoregisterSM icon on your registration card or register via
the Frigidaire App.