UEBEX MID2F LED Floodlight Instruction Manual
- August 29, 2024
- UEBEX
Table of Contents
UEBEX MID2F LED Floodlight
DIMENSION
INFORMATION ON THE EU ECODESIGN DIRECTIVE
- Important information on the energy efficiency of UEBEX luminaires, as well as on the EU Ecodesign Regulation can be found at www.uebex.com
This product contains light sources of energy efficiency class B, C and D.
SAFETY INSTRUCTIONS
- The installation and commissioning of the lamp may only be carried out by authorized specialists.
- The manufacturer is not liable for damage resulting from incorrect installation, improper operation or unauthorized modifications to the lamp.
- The luminaire is used separately for lighting and must be installed in accordance with the national installation regulations. Any other use or installation is considered „not as intended“.
- Caution, risk of electric shock. Before maintenance and installation work, disconnect power lines and existing control lines and check that they are voltage-free.
- Interruption of the neutral conductor during operation can lead to overvoltage damage to the lighting system.
- Commissioning only after the maintenance or installation phase, if a continuous mains voltage can be ensured.
- Make sure that the supply voltage matches the rated voltage of the luminaire. Pay attention to the recommended cable cross-section of the supply line.
- Risk of injury from falling luminaires or parts in the event of improper installation.
- The luminaire must not be operated at ambient temperatures which deviate from the values specified in the luminaire data sheet.
- Ensure sufficient air circulation of the luminaire. Minimum installation distances must be observed.
- In the case of vertical wall mounting, the cable entry must be from the underside. Through-wiring is not permitted.
- Before opening the product carton, check if there is any damage or defect during transportation, if there is any damage do not use the product and inform your supplier.
- If the product is damaged, please keep it in the packaging and contact your supplier.
- The packaging and the lamp should be disposed of in an environmentally friendly manner in accordance with the applicable regional regulations.
- Avoid direct eye contact with the light source.
- For cleaning, wipe the light surface with a soft cloth soaked in neutral detergent. Do not use sandpaper, polishing powder, alcohol, benzine or other alkaline solutions, alcohol, benzine or other alkalis.
PRODUCT PARAMETER
OPERATING TEMPERATURE: -30°C ~+45°C
MOUNTING BRACKET
MOUNTING
-
Fix the bracket by expansion screw in proper size, as shown in the picture.
-
Adjust the mounting-angle for the lamp.
Attention: for asymmetric optics use 15° max. -
Connect with main supply by following instruction and light up.
-
Open the cover and stand up the bracket.
-
Stuck the AC-Cable in the correct slot.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>