Towelrads 2805BTU Eton Brushed Aluminium Towel Radiator Installation Guide

June 4, 2024
TOWELRADS

2805BTU Eton Brushed Aluminium Towel Radiator
Installation Guide

  • Please check that all parts listed are present before starting installation.

  • Valves are not provided, please make sure that you have them before you start.

  • Before drilling holes for the brackets please check that there are no hidden wires or pipes.

  • The plugs supplied are for hard walls masonry only. Please make sure you are using the correct plug for your wall.

  • Korle radiators are designed for closed heating systems.

  • The radiator should be fitted at least 100mm from the floor to maximize heat efficiency.

  • Noting the distances between bracket centers on the drawings, mark out the position of the brackets on the wall.

  • Drill holes to approximately 35-40mm depth using an 8mm drill bit and insert raw plugs (1).
    Using connecting screw (3) attach mounting bracket 1 (2).

  • Attach mounting bracket 2 (4) to the radiator.

  • Guide all mounting brackets (4) into mounting brackets (2) and fix with connecting screws (5) and Bolt Nuts (6).

  • Connect the water flow. To ensure good circulation of water inside the radiator, ensure that the water flow pipe is connected to the correct side of the radiator using appropriate 1/2inch BSP valves sealed with PTFE tape on the threads.

  • After fitting you must be sure that your system is thoroughly flushed through to remove any residual particles. Although your aluminum radiator will not rust, you should be sure that a suitable inhibitor is used to protect your system and is refilled.

  • Fill the radiator and purge any trapped air using a flat screwdriver to open the bleed valve at the top of the radiator.

  • Wipe your radiator down using a clean damp cloth. Never use scourers or abrasives.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

TOWELRADS User Manuals

Related Manuals