nORLYS ASKER Big LED Bollard Light Instruction Manual
- August 21, 2024
- nORLYS
Table of Contents
nORLYS ASKER Big LED Bollard Light
Product Information
- Brand: ASKER
- Input Voltage: ~220-240V
- Frequency: 50-60Hz
- IP Rating: IP65
Product Usage Instructions
Installation:
For the installation of the ASKER product, it is recommended to hire a
licensed electrician for proper setup. Ensure the correct voltage input
(~220-240V) and frequency (50-60Hz) are provided. The product is suitable for
use with concrete/beton or wood/bois/holz surfaces. Use ethafoam during
installation to prevent damage.
LED Replacement:
LED module replacement should only be carried out by a professional service
provider. The product manual specifies the compatible replacement parts and
the torque settings for secure installation.
Maintenance:
Regularly check for grease accumulation and clean as necessary. Ensure all
connections are secure and free of any damage or wear.
FAQ:
-
Q: Can I replace the LED module myself?
A: No, LED module replacement should only be done by a professional service provider to ensure proper installation and compatibility. -
Q: What should I do if the IP rating is compromised during installation?
A: If the IP rating is compromised due to incorrect installation, contact a licensed electrician to rectify the issue. Damage to the IP rating may void the warranty.
Installation Instruction
ASKER
CONCRETE/BETON
Due to maintaining a high degree of IP thihtess, the luminaire was classified as an equipped product. LED module replacement is only possible by professional service.
- The light source contained in this luminaire shall only be replaced by the manufacturer his service agent or a similar qualified person.
- Turn off the power before replacing the light source.
- Replace any cracked protective screen.
- Only pierce the NORLYS gasket with the installation cable of 7-10,5mm diameter. Damage caused by tools will lead to IP degradation. Wrong installation leads to loss of warranty.
ASKER PRO
CONCRETE/BETON
Optical kit with IP67 (LED module and lens); electronic power supply. Replaceable (LED only) light source by a professional. Replaceable control gear by a professional.
- The light source contained in this luminaire shall only be replaced by the manufacturer his service agent or a similar qualified person.
- Turn off the power before replacing the light source.
- Replace any cracked protective screen.
- Only pierce the NORLYS gasket with the installation cable of 7-10,5mm diameter. Damage caused by tools will lead to IP degradation. Wrong installation leads to loss of warranty.