ARIEL 67761994 Sink Basin Installation Guide
- August 16, 2024
- Ariel
Table of Contents
ARIEL 67761994 Sink Basin
STOP, please make sure the cabinet is level before installing the countertop
COMPONENTS
- Base cabinet
- Hardware
- Countertop*
- Sink basin*
- Backsplash*
*Not included in Base Cabinet products .
TOOLS
- Permanent marker
- Caulking gun
- Power Drill
- Drywall Screws
HARDWARE
STEP 1 – PLACE & TRACE
Place the sink basin on the bottom of the countertop, making sure to center
over the opening. Draw guidelines on the countertop and the basin in two
locations.
STEP 2 – PREPARE SINK BASIN
Using a caulking gun, apply a heavy amount of silicone of your choice on the
top side of the sink basin edge.
STEP 3 – FLIP & SET IN PLACE
Carefully flip the sink basin over and place it so the guide lines match up in
both locations.
STEP 4 – DRY & SET
Press down on the sink basin to seal the silicone. Remove any excess. Follow
dry time recommendation found on your product, typically 12 to 24 hours.
STEPS – ATTACH UNDER MOUNT CLIPS
Please tighten Bolt (A) into wing nut (Bl slide on washer (C) and guide
through Under-mount clip (D) opening into threaded bolt hole in the
countertop. ONLY-Hand Tighten Bolt (A) to a depth of about 1/4″ below
countertop surface. Then secure the Sink with the under-mount clip (D) by
Tightening wing nut (B) only
STEP 6 – ATTACH BASE CABINET TO WALL
Place cabinet in desired location and determine where the wall studs are.
STEP 7 – PREPARE BASE CABINET
Using a caulking gun, apply silicone around the top of the base cabinet.
STEPS – SET COUNTERTOP IN PLACE
Carefully place the countertop, with the sink attached, onto the cabinet and
press down firmly.
Wipe away any excess silicone immediately.
STEP 9 – SET BACKS PLASH
After the vanity is in place, use a caulking gun to apply silicone to the back
and bottom unfinished sides of the backsplash. Press firmly down and back to
set in place. Remove any excess silicone.