ARIEL Base Cabinet with Countertop Installation Guide

June 1, 2024
Ariel

ARIEL Base Cabinet with Countertop

ARIEL Base Cabinet with Countertop

STOP, please make sure the cabinet is level before installing the countertop

INCLUDED

  • Base cabinet
  • Countertop
  • Sink basin
  • Backsplash
  • Hardware

NEEDED

  • Permanent marker
  • Caulking gun
  • Power Drill
  • Drywall Screws

HARDWARE

  • Bolts (4)

  • Wing nuts (4)

  • Washers (4)

  • Undermount clips (4)

Installation Instruction

STEP 1 – PLACE & TRACE
Place the sink basin on the bottom of the countertop, making sure to center over the opening. Draw guide lines on the countertop and the basin in two locations.

Installation Instruction

STEP 2 – PREPARE SINK BASIN
Using a caulking gun, apply a heavy amount of silicone of your choice on the top side of the sink basin edge.

Installation Instruction

STEP 3 – FLIP & SET IN PLACE
Carefully flip the sink basin over and place it so the guide lines match up in both locations.

Installation Instruction

STEP 4 – DRY & SET
Press down on the sink basin to seal the silicone.
Remove any excess. Follow dry time recommendation found on your product, typically 12 to 24 hours.

Installation Instruction

STEP 5 – ATTACH UNDERMOUNT CLIPS
Please tighten Bolt (A) into wing nut (Bl slide on washer (C) and guide through Under-mount clip (D) opening into threaded bolt hole in the countertop. ONLY-Hand Tighten Bolt (A) to a depth of about 1/4″ below countertop surface. Then secure the Sink with the under-mount clip (D) by Tightening wing nut (B) only

Installation Instruction

STEP 6 – ATTACH BASE CABINET TO WALL
Place cabinet in desired location and determine where the wall studs are.

Installation Instruction

STEP 7 – PREPARE BASE CABINET
Using a caulking gun, apply silicone around the top of the base cabinet.

Installation Instruction

STEP 8 – SET COUNTERTOP IN PLACE
Carefully place the countertop, with the sink attached, onto the cabinet and press down firmly.
Wipe away any excess silicone immediately.

Installation Instruction

STEP 9 – SET BACKSPLASH
After the vanity is in place, use a caulking gun to apply silicone to the back and bottom unfinished sides of the backsplash. Press firmly down and back to set in place.
Remove any excess silicone.

Installation Instruction

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals