AQUASCAPE AUSTRALIA Contractor Foam Gun Applicator Instructions
- August 8, 2024
- AQUASCAPE AUSTRALIA
Table of Contents
AQUASCAPE AUSTRALIA Contractor Foam Gun Applicator
Product Information
Specifications
- Model: [Insert Model Number]
- Dimensions: [Insert Dimensions]
- Weight: [Insert Weight]
- Power Source: [Insert Power Source]
- Material: [Insert Material]
Product Usage Instructions
- It is essential to maintain your product regularly to ensure optimal performance and longevity.
- Here are some maintenance tips:
FAQ
- Q: How often should I perform maintenance on the product?
- A: We recommend performing maintenance every [Insert frequency], or as needed based on usage.
- Q: Can I use the product with an external power source?
- A: Yes, the product is compatible with external power sources. Please refer to the user manual for specific requirements.
Contractor Foam Gun Applicator – Instructions and Maintenance
Instructions
Step-by-Step Instructions
- Before putting a can of foam on the gun for the first time, press the trigger down to release any air that may be in the barrel
- Shake the foam pressure-pack can and screw the can to the gun. DO NOT OVERTIGHTEN.
- Squeeze the trigger to allow the foam to fill the barrel
- Adjust the flow by tightening or loosening the flow-adjustment screw found at the back of the gun
- For best results, mist the area to be foamed with water first. The hygroscopic foam setting process is aided with the water dampness of the substrate.
- When finished, tighten the flow-adjustment screw fully until the trigger is locked
Maintenance
- Always keep a can on the gun. Failure to do so will cause the foam to harden in the gun barrel to permanently clog the gun
- The nozzle tip can be cleaned using a wire brush or similar. DO NOT scrape on a rough surface such as the concrete footpath bricks or rocks
- When changing over cans we recommend squirting Foam Professional Gun Cleaner – 22011 into the can receiver inlet of the gun to free up any foam and prevent the inlet from blocking
- If you prefer to clean the gun between jobs, ready for the next new spray can or the gun barrel is blocked, attach a can of Foam Professional Gun Cleaner – 22011 to flush out the barrel
- If the ball valve, located in the gun where the can is attached, becomes stuck, use a thin object such as a pencil to press down on the ball to release it
CONTACT
- (07) 5446 7963
- www.aquascapesupplies.com.au
- office@aquascapesuuplies.com.au
- 21 Progress Place
- Yandina QLD 4561, Australia
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>