ebluetimes L-WP-10L6-Qi2 Magnetic Wireless Power Bank User Manual
- August 7, 2024
- ebluetimes
Table of Contents
ebluetimes L-WP-10L6-Qi2 Magnetic Wireless Power Bank User Manual
Product Introduction
Thank you for choosing our Magnetic wireless Power Bank Please read over carefully and keep this manual for your records
Charging the device
- Connecting the Type-C interface of the Magnetic wireless Power Bank to the power adapter Wired Charging the phone
- The Battery indicator glow white in charging mode
For a better charging experience, please use a power adapter above 20W
For a more accurate display of the power level, it is recommended to perform
two charge/discharge cycles.
Wireless Charging the phone
put the device on the middle of the phone back, it can be adsorbed automatically and charging the phone at the same time When using wireless charging, the wireless charging indicator is always on: after disconnecting from the phone, the wireless charging indicator flashes slowly for 10 seconds and then turns off: when the wireless charging area touches a metal foreign object, the wireless charging indicator flashes quickly.
Wired Charging the phone
Use the charging cable to connect the magnetic wireless power bank and your phone
Wireless applicable device
Devices built-in wireless charging receiver and support fast wireless charging (Galaxy S9 Plus/S10/S10 Plus/Note 10/Note 10 Plus, Huawei P30 Pro/Mate30/Mate30 Pro/P40 Pro stand charger for Iphone XS Max/Xr/11/11 Pro/11 Pro Max and all Qi-enabled devices)
Magnetic charging equipment iPhone 12/13/14/15 series and above models
Specifications
| Model No | L-WP-10L6-Q12 |
|---|---|
| Capacity | 10000mAh/3.87V/38.7Wh |
| Rated Capacity | 6000mAh(5V-2A) |
| Type-C Input | 5V 3A/9V2.22A |
| Type-C Output | 5V2A/9V 2.22A |
| Wireless Output | 15W Max |
| Transmission distance | $3-6mm |
| Charging efficiency: | ≥75% |
| Size: | 102×70×14.3mm |
| Unit weight: | =188G (NW) |
| FCC ID: | 2BG9U-L-WP-10L6-012 |
Standard accessories
Magnetic Wireless Power Bank
Type-C cable
User Manual
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
ISED Canada Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.
IC Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>