Smowo 20 Pieces of Transparent Shrink Film Instructions
- July 23, 2024
- Smowo
Table of Contents
Smowo 20 Pieces of Transparent Shrink Film Instructions
Warning
For safety reasons, the shrink plastic should only be heated in the oven under the supervision of an adult!
-
Draw a motif on the matte side of the foil with a colored pencil or a waterproof felt-tip pen.
-
Carefully cut out the motif. If the element is to be hung up later, punch holes in it with a paper punch or punch pliers.
Note: The surface of the motif, and thus also of the hole, is reduced by about half when shrinking. Therefore, make the hole large enough.
-
Preheat the oven to approximately 150–160°C with top and bottom heat (without fan). Place the shrink film with the painted side up on a baking grid lined with baking paper or aluminum foil. The plastic film starts to bend and turn after a short time
-
Wait until the motif flattens out and stops moving. The shrinking process is then complete, and the motif is approximately 50–60% smaller. Remove the motif from the oven and press it down with a book to completely flatten it. Once the motif has cooled and hardened, it will be significantly smaller, thicker, and firmer.
To seal the painted side of the shrink film, we recommend clear varnish (nail varnish) to prevent possible wear.
Your opinion is important to us
For any questions or suggestions, you can reach us at: service@smowo.de
smowogermany
smowogermany
WARNING! Small parts. To be used under the direct supervision of an adult
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>