SFE Kites 4477 7-25 MPH SFE Light To Heavy Kite Instructions
- July 16, 2024
- SFE Kites
Table of Contents
SFE Kites 4477 7-25 MPH SFE Light To Heavy Kite
Product Specifications
- Recommended Wind Speed: 5 – 20 mph for Extra Light to Heavy, 20 mph and up for Extra Heavy
- Kite Tow Line Test Strength: A) 50 lb. Test for Extra Light to Heavy, B) 80 lb. Test for Extra Heavy
Kite Assembly
- Unfold the kite and separate the Direct Lift Control bridle from the Front bridle.
- Install the Struts in the centerpiece with alignment marks facing away from the kite.
- Attach the kite corner tip sockets to the spars.
- Ensure bridles are not wrapped around spars, tips, or centerpieces to prevent excessive roll during flight.
- . Make sure bridles are not wrapped around spars, tips, or centerpieces. Excessive Roll in flight will occur if these conditions exist.
Before Launching Kite
Ensure the following steps are completed before launching the kite:
Recommended Kite tow line A) Extra Light to Heavy 5 – 20 mph 50 lb. Test Extra
Heavy 20 mph and up 80 lb. Test
- Check that the Direct Lift Control Bridle is not wrapped around struts or centerpieces.
- Verify that the Front Bridle is not wrapped around kite tip sockets.
- Ensure all strut alignment marks are set and struts are fully seated in the centerpiece.
- Adjust the bridle slide for the wind conditions.
- Secure the tow line to the kite.
- All strut alignment marks are set and struts are fully seated in the centerpiece.
Bridle Flight Adjustment
For flight adjustments, follow these guidelines:
- Fly HIGHER by moving the bridle slide up, and Fly LOWER by moving it down.
- Extend bridle adjustment beyond reference marks if needed for optimal performance.
- Make fine height adjustments with 1/8th movement.
Note
- Do not interchange kite spars between kites.
- Rinse the kite with fresh water after each use to prevent saltwater from affecting flight characteristics.
- In case of excessive rolling, refer to Before Launch Instructions.
- Extreme pressure may cause the kite tow line to break.
- Fly UP – move bridle slide up
- Fly Down – move bridle slide down
- Extending Bridle adjustment beyond reference marks may be needed to maximize kite performance.
- Bridle marks are recommended reference positions.
- Fine height adjustments should be made with 1/8th movement.
- Kite will perform in extra heavy wind with conditions and limitations.
- Extreme pressure on the kite may cause the kite tow line to break. Kite retrieval will be difficult.
- Do not interchange kite spars from kite to kite.
- If the kite rolls excessively, refer to Before Launch Instructions.
- Always rinse the kite with fresh water after each use, as salt water will affect flight characteristics. If the kite is submerged, stop the boat and retrieve the kite gently.
FAQs
Q: What should I do if my kite rolls excessively during flight?
A: Refer to the “Before Launching Kite” instructions to ensure proper assembly and alignment of components.
Q: How should I adjust the kite for different wind conditions?
A: Move the bridle slide up for higher flight and down for lower flight. Make fine adjustments with 1/8th movement.
4477 US Hwy 27 S
Sebring, Fl. 33870
863-314-6088
Sfekites.com
Read User Manual Online (PDF format)
Loading......