Sensata HUBLITE Transceiver Owner’s Manual
- July 15, 2024
- Sensata
Table of Contents
Sensata HUBLITE Transceiver
Product Information
Specifications
- FCC ID: 2ATIMHUBLITE
- IC: 25094-HUBLITE
- Compliance: Part 15 of FCC Rules, Licence exempt RSS standards of Industry Canada
- Operating Conditions: Must not cause harmful interference, must accept any received interference
- Radio Frequency Exposure: Operate with a minimum separation distance of 20 cm (8 inches) from the body
Product Usage Instructions
Initial Setup
- Ensure the device is placed at least 20 cm away from the body before powering on.
Powering On
- Press and hold the power button for 3 seconds to turn on the device.
Connecting to Other Devices
- Use the provided cables to connect the device to other compatible devices.
Operating Conditions
- Always maintain a minimum separation distance of 20 cm between the device and the body during operation.
Maintenance
- Regularly clean the device using a soft, dry cloth to prevent dust buildup.
FAQ
- Q: What should I do if the device does not power on?
- A: Check the power source and ensure the device is charged or connected properly.
- Q: Can I use the device while charging?
- A: Yes, you can use the device while it is charging, but ensure it is done safely.
Introduction
The device under test is manufactured by the grantee (Sensata Technologies)
and sold as an Aftermarket product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033,
15.15(b) etc…, the grantee must ensure the end-user has all
applicable/appropriate operating instructions. When end-user instructions are
required, as in the case of this product, the grantee must notify the end-
user.
Sensata Technologies will include the contents of this document in the
end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER’S MANUAL
- The following information (in blue) must be included in the end product user’s manual to ensure continued FCC and Industry Canada regulatory compliance.
- The ID numbers must be included in the manual if the device label is not readily accessible to the end user.
- The compliance paragraphs below must be included in the user’s manual.
FCC STATEMENT
FCC ID: 2ATIMHUBLITE IC: 25094-HUBLITE
This device complies with Part 15 of the FCC Rules and with Licence-exempt RSS
standards of Industry Canada.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Exposure to radio frequency energy
- The radiated output power of this device meets the limits of FCC/ISED Canada radio frequency exposure limits.
- This device should be operated with a minimum separation distance of 20 cm (8 inches) between the equipment and a person’s body.
WARNING: Changes or modifications not expressively approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The term “IC:” before the radio certification number only signifies that Industry Canada’s technical specifications were met.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>