3DJAKE CR-M4 3D Printer User Guide
- June 3, 2024
- 3DJAKE
Table of Contents
3DJAKE CR-M4 3D Printer
Adjusting Pulley Tightness
X/Z-axis Pulley Adjustment
Before switching on the machine, please check the tightness of the pulley by
gently toggling it with your hand and check if it is idling or stuck as shown
in Figure A). if yes, please use an open-end spanner to adjust the hexagonal
eccentric isolation column to make it rotate smoothly.
Auto Leveling
- Click on Settings Leveling” in the main interface, and then click on “Start” after the machine has returned home, and wait for the machine to detect the platform to finish the auto leveling.
- Click on “Move Axis” in the settings screen, observe the height value of the Z-axis, set the value to 0 and then click on “Move Axis” to return.
- Click on “Z-axis Compensation” and observe the gap between the nozzle and the platform by adjusting the Z-axis compensation value so that the distance between the nozzle and the platform are about the thickness of a piece of an A4 paper.
- Observe the print result after starting printing, and adjust the Z-axis compensation again if any exceptions Occur
Filament Infill
Preheating Method
- A. Preheating mode 1 : Click on “Temperature” to select the auto temperature setting and choose PLA/ABS according to the type of filaments.
- B.Preheating mode 2 : Click on “Temperature” and select manual temperature setting, enter the corresponding values in the “Extruder Preheating” and “Hotbed Preheating” boxes.
Note: The standard printing preheating parameters have been adjusted upon delivery. For PLA preheating: nozzle temperature 200 hotbed temperature 60; for ABS preheating: nozzle temperature 250, and hot bed temperature 100. if you need to make adjustments due to reason of material to be printed or other reasons, you can adjust it separately under the Iemperature Manual setting on the home screen.
Flament intill
- A. When you wait for the temperature to rise, hang the filament over the material rack.
- B. Pass through the Filament Sensor, then press the extruder handle and insert the filament along the extruder hole to the nozzle position. if the filament flows out of the nozzle when the temperature reaches the target value, the filament is properly loaded.
Replacement of ailments:
- When the machine has just started printing, cut filaments near the extruder and slowly feed filaments until they are fed into the material barrel.
- When printing has finished and the machine has cooled down, heat the nozzle to 185C+, then draw the filaments out and replace them by rereming to step 1.
- To change the filaments during printing, adjust the printing speed to 10% and refer to step 2 for replacement.
Start Printing
Installation and use of the Creality Print slicing software
The above interface is for reference only.
Print Method
Local printing from a USB flash drive
CAUTION
- For details on using the software, please refer to the slicing software user manual on the storage card.
- Do not plug or unplug the USB flash drive during the printing process.
Tips: The fhle name must only contain Latin letters and digits.
Chinese characters or special symbols must not be used.
Download and install Creality Cloud
The above interface is for reference only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>