Nextgenagain WS900 Wireless Water Detector User Manual
- June 5, 2024
- Nextgenagain
Table of Contents
Nextgenagain WS900 Wireless Water
**Detector User Manual**WS900 MANUAL
Water sensor Operating Instructions:
WS900 is a wireless water detector designed to alert in the case of flood, leaks, and potential water damage solutions.
Installation:
The sensor and transmitter mount with either the screws or two-sided tape.
- Pull tab on back of cover, remove cover and insert battery (cr123a).
- Led will flash red to show power to the unit. (PLUS ver. will flash and sounder will beep).
- Replace the cover and click in the back plate.
Installation of the transmitter. The higher the location the better the range. Avoid metal studs and metal objects.
Install the sensor at the desired monitoring location. Both metal contacts need to come into contact with water to activate the sensor. (mounting too low will cause false alarms)
Programming
Following instructions are a guideline for programming. For more details see hub instructions.
- program button
- reset button
- on/off switch
PROB button (sensor test button)
Press reset button to test the sensor.
Green led flash indicates sensor connected to transmitter correctly and ready
for use
Red Led flash indicates sensor not connected to transmitter correctly or
sensor is in water
RESET Button
Press reset button to learn in the senor to the hub. Green led will flash to
show transmission
ON/OFF switch
Switch turns the sounder ON and OFF
Box contains:
1 completer water sensor
4 mounting screws Strip of two-sided tape
1 CR123A 3V lithium battery
SPECIFICATIONS:
PART NUMBER:WS900
BATTERY: CR123A (REPLACEABLE)
RF FREQUENCY 900MHz
OPERATING HUMIDITY: 0-90%
OPERATING TEMPATURE 32F (0 C) – 120F (49C )
DIMENSIONS: 3.5” X 1” X.85”
WEIGHT: 1.76 oz
FCC statement
This device complies with FCC rules part 15 operation is subject to the
following two conditions
This device may not cause harmful interference. This device must accept any
interference received including interference that may cause undesired
operation
FCC caution
The user that changes or makes modifications not expressly approved by the
party responsible for compliance could void the users authority to operate
this equipment
FCC Compliance Statement Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. FCC Warning (Part 15.21). Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Interference Statement (Part 15.105 (b)). This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>