SONGYI 1:24 Spray Forklift Truck Instruction Manual

SONGYI 1:24 Spray Forklift Truck Instruction Manual

Thank you for purchasing one of our toy products. To ensure that you get the most out of your new purchase, please read these instructions carefully before using the toy for the first time. They contain important information on how to operate the product.

Caution:

• Electrical product
  This product is not suitable for children aged 6 or under. When using electrical products, precautions must be taken to prevent the risk of an electric shock.

• Ensure adult supervision at all times
  Warning : Do not attempt to modify or re-assemble this product. Unauthorised changes may void your right to use the product.

Charging the batteries

1. Insert the USB plug into an indoor USB power supply, and then connect the battery compartment to the charging cable.
2. The charging time is about 120 minutes. Flash red light when charging
3. Regularly inspect the toy, battery charger, charging cable, connectors and other components for signs of damage. In the event of any damage, discontinue use and send the parts for repair.

Calibrating the vehicle

Instructions:

• Check that the ON/OFF switch is in the “ON” position. The vehicle will not respond to the remote control when the switch is in the”OFF” position.
• If the vehicle strays to the left, move the calibration dial to the right until the vehicle travels in a straight line.
• If the vehicle strays to the right, move the calibration dial to the left until the vehicle travels in a straight line

Inserting the remote control batteries

1. Observe the polarity markings on the battery compartment to ensure that the batteries are inserted in the correct polarity.
2. Attach the cover to the battery compartment as shown in the diagram below.
3. Insert rechargeable batteries into the battery compartment.
4. Use a screwdriver to secure the battery compartment cover in place.

two of 1.5V “AA”batteries
The remote control needs two of 1.5V “AA”batteries Non rechargeable batteries (Needs to be purchased separately)

Inserting the battery compartment into the vehicle

After the battery is connected to the USB charger, plug it into the computer or USB charging head for charging. The charging time is about 2-4 hours, and then it can be pulled out for use.

Basic controls

1. Pull up the remote control throttle, the car will move forward.

2. Pull down the remote control throttle, the car will move backward.

3. Turn left the remote control throttle, the car will left tum,

4. Turn right the remote control throttle, the car will right turn.

5. Attention : When injecting purified water, please pay attention not to splash the car to prevent short circuit of circuit board.

be careful: Unscrew the lid. When adding water, it is recommended to inject purified water. When adding purified water, avoid overflowing the bottle mouth, cover the lid, and do not pour water into the spray port.

Using the vehicle

1. Switch on the vehicle using the ON/OFF switch.
2. If the vehicle does not move in a straight line, adjust the calibration dial on the bottom of the chassis.
3. Switch off the vehicle and remote control after use.

Battery safety information

1. The batteries must only be charged under adult supervision.

2. Before charging the batteries, remove the battery compartment from the vehicle chassis.

3. Remove empty batteries from the vehicle and remote control.

4. Ensure that the vehicle is switched off before inserting the batteries.

5. Ensure that the batteries are inserted in the correct polarity (observe the + and-markings on the battery
   compartment).

6. Do not attempt to charge non-rechargeable batteries.

7. Do not short circuit the battery terminals.

8. If you do not plan to use the vehicle for an extended period, remove the batteries from the Vehicle and remote control to prevent leakage.

9. Do not throw batteries into open flames, as this may cause them to explode or leak.

10. Do not mix old and new batteries or batteries from different manufacturers.

11. Only use batteries from recommended or reputable manufacturers.

12. Regularly inspect the batteries for signs of leakage.

13. Keep this instruction manual in a safe place for future reference. It contains important information on how to use the product safely.

Care and maintenance

1. Remove the batteries when you do not plan to use the toy for an extended period
2. Use a damp cloth to wipe the vehicle dean.
3. Do not expose the toy to high temperatures, moisture or direct sunlight.
4. Do not immerse the toy in water, as this may damage the electrical components.

Caution

1. Do not touch the wheels when the vehicle is moving, as this may damage the vehicle.
2. This device may not cause harmful interference, and
3. this device must accept any interference received, including interference that may cause undesired operation.

Do not use the vehicle in puddles, mud or sand.

Do not use the vehicle next to roads or other hazards, as this may cause an accident.
Accessory Manufacturer: Shantung land Toys Co., Ltd.
Address of Manufacturer: South Industrial Zone of Wannabe Village Road, Liliana Town, Chennai District, Shantung City Guangdong Province China
Operating temperature: -20C to +55 C
We declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU,
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE, DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Operation Maximum Frequency: 2404MHz-2452MHz

WARNING:
CHOKING HAZARD-Small parts. Not for children under 3 years.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>