EVERLAST CLIMBING Adaptive Climbing Wall Instruction Manual
- June 3, 2024
- EVERLAST CLIMBING
Table of Contents
EVERLAST CLIMBING Adaptive Climbing Wall
NOTE:
Hand Holds are only for use with certain Everlast ClimbingTM walls. Call for
details. Please use provided mat loop extensions, if adding holds to the wall
with the existing mat-locking system.
FOOTHOLD INSTALLATION INSTRUCTIONS
(Please read all instructions thoroughly before starting to install)
- Place Adaptive Foot Hold over desired hole pattern ~ 12” apart for the blue foot holds or ~ 24” apart for the red foot holds.
- Insert 3/8” x 5 ½” Hex bolt with a 3/8 washer into slotted holes, find the T-nuts, and hand screw them in to start them.
- Using a 9/16 “socket in a socket wrench, ratchet the bolts tight.(Take care not to cross-thread the T-nuts.)
Adaptive Foot Hold Hardware
- < 9/16” socket & socket wrench (NOT included)
- < 3/8” x 5 ½” hex bolt with 3/8” washer (included)
HANDHOLD INSTALLATION INSTRUCTIONS
(Please read all instructions thoroughly before starting to install)
- Insert 3/8” x 2” bolt through Adaptive Hand Hold and into the climbing wall.
- Place Adaptive Hand Hold over the desired hole (T-nut) in the wall, lining up the hole in the handhold with the hole in the climbing wall.
- Using the special 5/16 Allen Wrench (included), gently start threading the bolt into the T-Nut. (Take care not to cross-thread the T-nuts.) Spin the wrench and tighten the hold to the desired position (vertical, horizontal, or angled).
Adaptive Hand-Hold Hardware
- 5/16 Allen Wrench (included) >
- 3/8” x 2” Bolt (included) >
THE PROPER CARE AND ONGOING MAINTENANCE OF YOUR CLIMBING WALL IS ESSENTIAL AND IS YOUR RESPONSIBILITY. PLEASE REFER TO THE SAFETY, CARE, AND MAINTENANCE INSTRUCTIONS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>