imuto MS-P3 Magnetic Wireless Power Bank User Manual
- June 4, 2024
- imuto
Table of Contents
USER MANUAL
Magnetic Wireless Power
MS-P3
IMPORTANT SAFETY INSTRUCTIONS
When using this product, basic precautions should always be followed, including the following:
- Store the product in a cool, dry place.
- Do not store the product in a hot or humid environment.
- Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
- The operating temperature should be between 0°C to 35°C / 32°F to 95°F.
- Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
- If the product is not used for long periods of time, you should charge and discharge it once every three months.
- When charging a device, the product may feel warm. This is a normal operating condition and should not be a cause for concern.
- In normal conditions, the battery performance will decline over several years.
- Do not dispose of the product in heat or fire.
- Do not clean the product with harmful chemicals or detergents.
- Misuse, dropping, or excessive force may cause product damage.
- When disposing of secondary cells or batteries, keep cells or batteries of
- Be aware that a discharged battery may cause fire or smoke. Tape the terminals to insulate them.
At a Glance
- Wireless Charging Indicator
- Battery Level Indicator
- USB-C Port
- Power Button
Charging the iPhone 12 Series or Later
Charging the Phone 12 Series or Later To activate wireless charging, press the power button or place your device on the charger as illustrated below and it will be held in place magnetically.
Recharge Your Portable Charger
Specifications
| Capacity | 5000mAh / 19Wh / 3.8V |
|---|---|
| USB-C Input | 5V 2A |
| USB-C Output | 5V 2.4A |
| Wireless Output | 10W(Max) |
| Total Output | 12W(Max) |
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
For FAQ or more information
Customer Service:support@imuto.com
Or Visit:www.imuto.com
Muto Lim ited1291 Brighton Road, South Croydon, CR2 6EQ the United
Kingdom 
http://imuto.clubscan=1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>