hyh HC-02Y Smart Lock User Guide

02 Series Instruction

SPECIFICATIONS

Different Types Installation Videos

| |
---|---|---

https://www.youtube.com/watch?v=Gbiym-G86JY

|

https://www.youtube.com/watch?v=ZJeopUPHa8M

|

https://www.youtube.com/watch?v=EEpkti- 5wdA

Latch: 24-25.5mm, 30-31.5mm, 35-36mm, 36-40mm
02 Suitable Door Thickness| Slider: 37-56mm
Latch: 37-39mm, 44-45mm, 48-50mm, 53-54mm
Application| Sliding door, wooden door and aluminum door

APP SETTING

Search Tuya Smart in app store or scan the QR code, register an account and login.

https://smartapp.tuya.com/tuyasmart

Step 1: Turn on Bluetooth Step 2: Open Tuya, touch the fingerprint to active the lock and choose add deviceStep 3: Add device Step 4: Choose done Step 5: Add device successfully

RESET

Step 1: Click the icon Step 2: Choose remove device Step 3: Choose disconnect and wipe data Step 4: Confirm

Accessories

Before installation

Door type: Special profiles Reserve a location for installing smart locks

1. Measure the size of door hole.
2. Drill the door hole will tool.

Install smart lock

1. Fix the front and rear panels to the aluminum material with screwsEnsure that the rear panel fork is at the top

Install locking device

1. Place “E” in “D”
2. Insert the locking device into the groove
3. Slide “D” down to the appropriate position where “F” can be put in the right place like ④
4. Install “F”
5. Press the rear panel switch so accessory “E” leans upwards
6. Tighten the screw

Install the buckle

1. Install “H”
2. Tighten the screws
   Before tightening the screws| After tightening the screws
   ---|---
   |
3. Align position

Accessories

Before installation
Reserve a location for installing smart locks

1. Measure the size of door hole.
2. Drill the door hole will tool.

Install smart lock

1. Fix the front and rear panels with screws align position
2. Installation “C”.
3. Install the latch
4. align position

FCC Warnning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>