CUPRESSUS YW-010 Romantic Solar Powered Lights Cypress Tree User Manual
- June 20, 2024
- CUPRESSUS
Table of Contents
CUPRESSUS YW-010 Romantic Solar Powered Lights Cypress Tree User Manual
PRODUCT SPECIFICATIONS
Model number: YW-010
Battery: 1.2V, 600mAh
Solar panel: 2V, 120mAh
Power: 0.5W
Waterproof rating: IP65
PRODUCT OVERVIEW
Rubber Protection
Upgraded solar panel to convert fast and efficiently
CHARGING
The unit is shipped with the power switch in the “OFF” position. Locate the
on/off switch on the solar panel and slide it into the “ON” position.
NOTE: Slide switch into the “ON” position and place solar panel in
the sun for at least 8 hours, The Watering Can will light automatically at
night.
OPERATION
-
Slide the switch to “ON” position.
-
This product will perform best if installed in a location that gets direct sunlight. (The solar panel will perform optimally if it receives 8 hours of direct sunlight per day.)
-
Keep the solar panel away from any light source at night if you want to enjoy its light.
NOTE: The CUPRESSUS won’t be turned on automatically at night if it is close to other light sources such as porch lights, landscape lights, street lights, etc. -
It can last up to 6-8 hours when fully charged and can be used indoors and outdoors.
NOTE: The duration of light depends on the geographic location, weather and the time of being exposed to sunlight.
TOUBLESHOOTING
- If your CUPRESSUS does not turn on, check the followings:
- The battery may not be fully charged – place in direct sunlight for 8 hours.
- Make sure the “ON/OFF” button of the solar panel is in the “ON” position.
- Make sure no other light sources are preventing the LED from automatically illuminating.
- Keep the solar panel of the Watering Can clean.
If CUPRESSUS does not light up after using 8-12 months, replace the rechargeable batteries. (1.2V Rechargeable Ni-MH AA Battery x 1 – ONLY USE THE SAME TYPE OF BATTERY!)
BATTERY REPLACEMENT
Step 1: Unscrew the battery compartment cover by using a Phillips head
screwdriver (not included).
The battery compartment is located under the solar panel.
Step 2: Remove the exhausted battery and install 1 pc new 1.2V
rechargeable Ni-MH AA battery.
Open the compartment carefully in order to ensure that welding wires of the
battery terminals are intact.
Step 3: Screw the battery compartment cover back and make sure it is
installed securely.
A BATTERY WARNING
- Battery must be recycled or disposed properly.
- Do not dispose battery near fire or put it into trash directly.
- Remove the battery from Watering Can if don’t use it for a long time.
- Removal and replacement of the battery should be carried out by an adult or under adult supervision
INSTRUCTIONS FOR RECYCLING AND DISPOSAL:
This label means that the product cannot be disposed of as other household
waste throughout the EU. To prevent potential damage tothe environment or
human health from uncontrolled waste disposal. Recycle responsibly to promote
the sustainable use of material resources. If youwant to return a used device,
use the drop-off and collection system, or contact the retailer from whom you
bought the product. The retailer can accept the product for environmentally
safe recycling.
A declaration by the manufacturer that the product complies with the
requirements of the applicable EU Directives 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>