BELAIR HOME 212925010 6W Light Memory 6 Speed 4 Retractable Blades User Manual

BELAIR HOME 212925010 6W Light Memory 6 Speed 4 Retractable Blades

THANKS FOR YOUR PURCHASE
Thank you for purchasing this product. To ensure proper operation and safety, please read and save all instructions before using the product.

SAFETY PRECAUTIONS

1. This device can be used by children from 8 years of age, by people with reduced physical, sensory or mental capacities, or by people without experience or knowledge if they have been provided supervision or instruction regarding the use of the device in a manner safe, and understand the dangers involved. Cleaning and maintenance must not be carried out by children without supervision.

2. Children must be supervised to ensure that they do not play with the device.

3. A switch to disconnect all poles must be incorporated in the fixed installation, by local wiring regulations.
   AN INSULATION SWITCH MUST BE INSTALLED WITH THIS FAN. Please note that the warranty will be void if the fan is installed without an isolation switch.

4. If you do not have electrical appliances such as municipal waste, use individual collections. Contact your local government for more information about available collection systems. If electrical appliances are disposed of in landfills or landfills, hazardous substances can seep into the groundwater and reach the food chain, damaging your health and well-being.

5. The structure to which the fan is to be placed must be capable of supporting a weight of 45 kg.

6. The fan must be installed so that the blades are at least 2.3 meters above the ground in Europe.

7. This fan is only suitable for indoor use.

8. Only a licensed electrician should perform the installation.

9. Use of a non-approved remote control will void the warranty. Therefore, do not control the operation of this fan from any other remote control that has not been approved by Bel Air Home for use with the fan.

UNPACKING YOUR FAN

Open the original box and check that it contains all the parts listed below. If any of these parts are defective, damaged, non-functional or missing, do not throw away the box or any other packaging in case it needs to be replaced or repaired.

1. Ceiling bracket
2. Upper trim
3. Extension pole (2 sizes)
4. Bolt and pin trim
5. Motor
6. Light kit
7. Diffuser
8. Remote control receiver
9. Remote control
10. Screw bag

UNPACKING YOUR FAN
Open the original box and check that it contains all the parts listed below. If any of these parts are defective, damaged, non-functional or missing, do not throw away the box or any other packaging in case it needs to be replaced or repaired.

HOW TO CHOOSE A GOOD LOCATION FOR YOUR CEILING FAN

1. According to the regulations and to provide a safe distance from the ground, the lowest point of the fan blade must be at least 2.1 metres above the ground.
2. For enclosed outdoor fans, the fan must be installed at least 1.5 m from the perimeter of the roof/eaves of the enclosure to protect the product from direct or indirect rain or sunlight.
3. The location chosen for the fan must not allow the rotating blades to come into contact with any object.
4. Please check carefully and make sure that the ceiling joists are strong enough and of the right size to support a weight of about 35 kg.
5. To reduce the risk of fire, electric shock, or personal injury, please ensure that the fan mounting bracket is directly supported by the building structure. Do not mount to an electrical outlet box.
6. Attach the fan blades once the fan motor housing has been installed and properly secured. Keep the fan motor and fan blades in the original packaging until ready for installation.
7. Check and confirm, once the fan is fully installed, that all connections are adequate and secure to prevent the fan from falling or causing damage to your property or personal injury.
8. Both the fan with the light kit (accessory) and the mounting bracket must be connected to an earth ground. Do not remove the fan from the ceiling after installation.
9. Ensure that the power is disconnected from the main power box before starting work. Turn off the power by removing the fuses or turning off the circuit breaker before installing the fan.

STEPS AND INSTALLATION INSTRUCTIONS (2)
It is recommended that the fan installation be performed by a professional or electrician for the warranty to be valid.

HANGING SYSTEM INSTALLATION

1. Feed the motor cables through the lower case, the upper case and the hollow rod (fig. 1 and 2).
2. Raise the fan and insert the hanging sphere from the hollow rod into the suspension bracket (fig.5).
3. Fit the hollow rod to the fan body and insert the suspension screw and lock it with the pin (fig. 3 and 4).
4. Connect the motor cables to the remote controller driver (use the colours of the 3 cables).
5. Secure the Driver in the suspension bracket and connect the power cables (fig.6).

FAN ELECTRICAL INSTALLATION MANUAL

Matters needing attention:

1. The receiver can not be mounted on the plane to avoid affecting the unevenness of the cover and ceiling.
2. Receiver sub-inputs and outputs are strictly prohibited from adjusting input and output pairs.
3. If there is a wall switch on the fan, it must be on to control effectively.
4. Wiring should be done according to the colour of the wire and the instructions on the sleeve.
5. When using the remote control, please check whether the battery is installed or not. Pay attention to the positive and negative poles of the battery. The control key of the handle flashes every key that is pressed.

RADIO FREQUENCY FAN REMOTE CONTROL INSTRUCTIONS

RESET CEILING FAN CONTROL

1. Turn off the wall switch and turn it on again.
2. Press the PAIR CODE button for thirty seconds with the remote control near the fan.
3. The remote control. The problem has been solved!

IMPORTANT:

1. Code pairing: Turn on the power and immediately press the three keys of “Fan stop – light on/off – Fan stop” after hearing the sound of “BEEP” (three keys are completed within 5 seconds). When the two sounds of “BEEP, BEEP” are heard, the code matching is successful.
2. If the remote control cannot be effectively controlled: please check the battery, and remove the battery if it is not in use for a long time.

• https://youtu.be/8Sdg522Hsao
• Visit this link and you will find a simple video of the assembly of your fan.

CARE AND CLEANING

1. Regular cleaning of your fan is the only maintenance requirement. Use a soft brush or lint-free cloth to avoid scratching the paint finish. Please turn off the power when you do this.
2. Do not use water when cleaning your ceiling fan. It could damage the motor and create the possibility of electric shock.
3. The motor has the bearing permanently lubricated. No need to supply oil.

NOTE: Before cleaning your fan, always turn off the power and disconnect the plugs.

TECHNICAL SPECIFICATIONS

• Model : EnergySilence Aero 5200 White Line/EnergySilence Aero 5200 Black Line
• Product reference: 05989/05990 60 W, 220-240 V – 50-60 Hz 18 W LED / Designed in Spain – Manufactured in China

RECYCLING OF ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol indicates that, according to the applicable regulations, the product and/or battery must be disposed of separately from household waste. When this product reaches the end of its useful life, you should remove the batteries/accumulators and take it to a collection point designated by the local authorities. For detailed information on the most appropriate way to dispose of your electrical and electronic equipment and/or batteries, consumers should contact their local authorities. Compliance with the above guidelines will help to protect the environment.

WARRANTY AND SAT
Cecotec will be liable to the user or end consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions and deadlines established by the applicable regulations. It is recommended that repairs are carried out by specialised personnel. If you detect an incident with the product or have any queries, please contact the official Cecotec Technical Assistance Service on +34 96 321 07 28.

COPYRIGHT
The intellectual property rights to the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorisation of CECOTEC INNOVACIONES, S.L.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>