Juiweo 300lbs Multifunctional Shower Chair Instruction Manual
- June 11, 2024
- Juiweo
Table of Contents
Juiweo 300lbs Multifunctional Shower Chair Instruction Manual
If you have any questions please contact the seller We will meet any of your needs
**The product structure diagram is as follows:
**
- Lift arm control switch
- back cushion
- armrest pad
- protective tube
- cushion cove
- plastic square bucket
- foot removal components
- M6 knob
- foot pedal
- M8 Torx knob
- PU pillow components
- PU pillow adjustment components
- backrest components
- cushion
- seat components
- low shelf components
- C-shaped buckle
- 5 inch wheel components
When you unpack the box, please pay attention to protect all the parts in the box. If you assemble on the ground, first put paper or carpet on the ground to prevent scratches. Pay attention to distinguish the parts, and then place them first. Well, there are bulk accessories in the box as shown below:1. Wheels 2, PU pillow head 3, protective tube 4, PU pillow adjustment components 5, foot removal components. Remove the bubble paper of the bulk component and place the accessories
Check after installation:
- Whether the toilet seat is installed correctly, please refer to the manual for comparison.
- Verify that all accessories are fully assembled, and check whether there are extra accessories.
- Check if the installation is loose. If it is loose, reinstall it.
- Check whether all components of the appearance are skewed and make appropriate adjustments.
Description of some components:
-
If you need to adjust the height and back-to-back distance of the PU pillow, loosen the M8 Torx knob to adjust the distance, and then lock it.
-
If you need to wash your hair, you must first press the brakes on the 5-inch wheels to ensure that the toilet seat is fixed, and then press down on the control arm switch on the backrest. Adjust the cushion angle according to your needs. As shown below
-
Before entering the seat to sit down, please hold down the marbles on the left and right side of the protective tube, sit down, and then press back to the original place.
Assembly instructions:
Step 1 : As shown in Figure 1 below, align the cannula of the backrest with the mouth ends of the two ends of the elbow on the seat components, and press firmly. Then lock the backrest components with the Torx knob.
Step 2 : Align the four wheel components with the corresponding holes in
the driver components
tube, and lock them with a C-shaped buckle, as shown in Figure 2
Step 3: Align the left and right foot removal components with the hole in
the front of the seat components and press down firmly, as shown in Figure
3.
Step 4: Insert the two protective tubes into the tube of the armrest
components, and align the marbles with the holes as shown in Figure 4.
Step 5: Insert the PU pillow adjustment components into the oval tube of
the backrest and lock it with the M8 Torx knob as shown in Figure 5.
Step 6: Insert the PU pillow into the oval tube of the PU pillow
adjustment components, and lock it with the M8 Torx knob as shown in Figure
6.
Documents / Resources
|
Juiweo 300lbs Multifunctional Shower
Chair
[pdf] Instruction Manual
300lbs Multifunctional Shower Chair, Multifunctional Shower Chair, Shower
Chair, Chair
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>