Cycle Visions Slick “Signals License” Plate Frame With Brake Light [CV-4620-Chrome Flat, CV-4620B-Black Flat] Instruction Manual
- June 8, 2024
- Cycle Visions
Table of Contents
Cycle Visions “Slick Signals” License Plate Frame With Brake Light
Instructions
Part # CV-4620-Chrome Flat
Part # CV-4620B-Black Flat
Parts included:
1 – License Plate Frame
4 – 10/24 x 5/8 set screws
4 – Flat Washers
4 – 10×24 Nyloc
Installation Time:
Approximately 1 hour or less.
Wire as follows:
Blue wire to run light circuit.
Black wire to ground.
Red Wire to brake light circuit
Connect the two purple wires to corresponding turn signal circuit.
NOTE :
-
Do not over tighten setscrews. USE LOCK-TITE
-
USE ALLEN WRENCH TO HOLD SETSCREW WHILE TIGHTENING LOCK NUT
We will not warranty if the setscrew goes through face of the frame. -
MAY require an additional load equalizer for proper operation depending on year and model of bike.
-
Important Note: Check break lights, If the two side lights turn amber for brake, you will need to Flash the BCM(Body Control Module) for a dedicated brake light. This can be done by most HD technicians.
Our Warranty Policy
Cycle Visions obligation under “Our Warranty Policy” is limited to one (1) year from date of purchase to repair or replacement of the defective item (s). Chrome, polished, powder-coated, anodized finishes, or electrical parts are limited to thirty (30) day from date of purchase.
This warranty will be void on all products that show evidence of misapplication, improper installation, abuse, lack of proper maintenance, negligence, or alteration from their original design.
The consumer will be responsible for removing from the vehicle any defective item (s), transportation costs prepaid and for reinstallation upon return by Cycle Visions. The loss of use of the product, loss of time, inconvenience, commercial loss or consequential damages is not covered. Cycle Visions reserves the right to change the design of any product without assuming any obligation to modify any product previously manufactured. Warranty returns of Cycle Visions products are few because of our high quality products.
Carefully inspect all parts…. If you find that your parts arrived in damaged conditional all original packaging material (box and other materials) must be saved to make a proper damage claim within seven (7) days. You must be able to present the damaged boxes and materials to the freight carrier to verify your claim. The user shall assume all legal, personal, injury risk and liability and all other obligations, duties and risks associated therewith.
Cycle Visions SM
San Diego, California (619) 295.7800
www.cyclevisions.com
See our other products on the web!
Rev. 02/06
Cycle Visions Slick “Signals License” Plate Frame With Brake Light
[CV-4620-Chrome Flat, CV-4620B-Black Flat] Instruction Manual – Download
[optimized]
Cycle Visions Slick “Signals License” Plate Frame With Brake Light
[CV-4620-Chrome Flat, CV-4620B-Black Flat] Instruction Manual –
Download