Morelax M208 Hand Massager with Heat Compression and Heating User Manual
- May 15, 2024
- Morelax
Table of Contents
HAND MASSAGER
User Manual
M208 Hand Massager with Heat Compression and Heating
Read this instructions carefully before use and store in a safe place for future reference
Thank you for purchasing this hand massager, it takes away the stress of everyday life and gives you a powerful massage experience like never before! This manual contains all the necessary setup and operating procedures to use your new hand massager. Also, be sure to read and follow the precautions and warnings of this manual, he teaches you how to operate your equipment safely and get the maximum life and performance from it, thank you again for choosing.
IN THE BOX
1x Hand Massager
1x USB charging cable
1x travel bag
1x User Manual
Control Panel
USB charging port, the red power light is flashing when charging, and the red power light is long bright when fully charged.
Step 1: Charging
Connect the USB cable to the hand massager port and any USB plug (laptop, wall
plug, etc.), the red light flashes when charging. The red light will be long
bright when the battery is fully charged.
Charging time
5V / 1A: about 5 hours
Operating hours
Normal use: about 3 hours
Heating and shaking: about 2 hours
Instructions for use
- Before the first use, charge the hand massager until the red power light is long bright.
- Place the device on a flat, level surface.
- Insert one hand into the cavity of the interlining.
- Press the “POWER” button to start the massage.
NOTE: Be sure to remove all sharp jewelry from your hands.
“POWER” BUTTON
Power on: Touch the “POWER” button, the hand massager is turned on, the hand
massager starts to work.
Power off: touch the “POWER” button. The airbag will gradually deflate.
The default massage run time is 15 minutes, which means the power will
automatically turn off after 15 minutes.
If you want to keep using it, you can start over.
NOTE:When the POWER light is flashing, please charge.
“INTENSITY” BUTTON
The default intensity is “I3”, 6 different intensity levels, from the weakest
“I1” to the strongest “I6”. You can press the “INTENSITY” key to increase or
decrease the intensity level.
“PROGRAM” MODE
The default mode is “P1”, and there are 6 modes in total. You can press the
“PROGRAM” key to select your favorite mode, the detailed description of each
mode is as follows.
P1 Combination of finger, palm and wrist massage
P2 Combination of finger, palm and wrist massage
P3 1st cycle palm massage
Second cycle: palm and wrist massage
P4 wrist massage
P5 1st cycle palm massage
Second cycle wrist massage
P6 palm massage
Each program massages and releases pressure on different parts of your hands,
palms and fingers according to your hand shape. This means that everyone will
experience a different and unique massage. You can select your preferred
program mode by pressing the Program button.
“HEAT” BUTTON
Press the button to turn the heating on/off. When the “HEAT” option is
activated, the red light above the button will illuminate.
The heating function provides gentle warmth around 104°F/40°C – which relaxes
and enhances the benefits of the massage.
“VIBRATION” BUTTON
Press the button to activate vibration mode. When the option is activated, the
light above the button will illuminate.
The hand massager offers 2 different vibration modes: pulse mode and
continuous mode. Press the button a few times to switch between modes
How to use a finger massager
This finger massager is for relaxing finger fatigue, just put your finger in the middle of the roller, roll back and forth for a wonderful and comfortable massage.
Precaution
We want you to enjoy your new hand massager safely. The precautions outlined in this manual should be strictly followed to ensure safe operation.
- Wash your hands before each use to keep the massager clean.
- Do not wear jewelry when using the hand massager.
- Don’t let the device charge overnight or all day.
- Avoid placing any filled glasses or liquid bottles next to the device as they may spill and damage equipment.
- Do not charge the device if the adapter or USB cable is damaged.
- Do not operate after taking painkillers, sedatives, or drinking alcohol.
- People with pacemakers should not use this product. Always consult a doctor before use.
- Do not use with wet hands or in damp places
- Please do not disassemble the unit
- If you suffer from diabetes, inflammation, blood clots, recent surgery and/or pregnancy, heart disease or osteoporosis, we recommend that you consult your doctor before using the massager.
- Do not use the device continuously for more than 30 minutes.
- Do not cover the massager while in use, this may cause the device to overheat.
- Don’t worry about the dimples on your hands after using the hand massager.
They will disappear within 30 minutes.
Warning:
Contact your doctor before using the hand massager if you have a medical
condition or any of the following:
- You are pregnant.
- You have a pacemaker or other medical implant.
- You have heart or blood vessel disease.
- You have irregular blood pressure or are receiving treatment to normalize your blood pressure.
- You have osteoporosis.
- You have cancer.
- You recently had surgery.
- This product should not be used by persons with any physical condition that restricts the user’s ability to move.
- Never leave the device unattended, especially if children are present.
- Never use this product directly on swollen or inflamed skin areas or open wounds.
- Do not use this product on persons with sensory impairments in the hands and appendages.
- We recommend that you limit the use of the massager to 15 minutes and use it continuously for no more than one hour (60 minutes).
Troubleshooting
When operating problems occur, refer to the table below.
| Question | Possible Reason | Solution |
|---|---|---|
| I can’t start the device. | The device does not start properly or the battery | |
| is low. | Press and hold the power button for 2 seconds or charge your device. | |
| The device suddenly stops working. | Power off or massage for more than 15 |
minutes or work for a long time, it has been shut down due to overheating
protection.| The unit switches off automatically after 15 minutes of use. Let
the motor cool down naturally before use.
Hearing a faint sounds when using the massager.| Air pump is working.| Normal
behavior.
Dimples on hands after massage.| From airbag cover.| Normal phenomenon,
disappear after 30 minutes.
Airbag not inflating.| Battery is low.| Charge the device.
No red lights are visible when charging or all lights are flashing and the
product is powered off.| The device is not charging properly, or the charger
voltage is too high.| Fully insert the USB cable interface into the USB port,
or the charger is 5V 2A.
Vibration feature doesn’t work.| Device can not fully charge.| Make sure the
massager is fully charged, if the problem still exists.
Heating function does not work unit is hot.| The device is not fully charged,
the heating option takes some time to reach the maximum temperature overuse|
Wait at least 10-12 minutes before feeling hot.
Turn off the device and allow it to cool before further use.
Massage is too stressful.| You are using an intensity level that is too high
or your hands are not positioned correctly in the device.| Use intensity level
1 or try adjusting your hand in the
device for comfort.
Massage pressure too low| Low battery or intensity level too low| Charge the
device or increase the intensity level.
How can I confirm that the product is fully charged?| | When the red light on
the display is long bright, it is fully charged.
Safety Notice
There is a lithium battery inside the hand massager. Batteries present a serious risk of fire and injury if they are mishandled, abused, or misused. The user must read and understand all instructions, warnings and cautions contained in the handling, care and use of the battery.
- Check the charger voltage before charging, the correct voltage is DC5V.
- Always charge the battery in a well-ventilated area.
- Charge the battery in a safe area away from flammable materials.
- Do not disassemble, crush, short-circuit or expose the battery to flame or other ignition sources.
- Be sure to unplug the charger from the wall outlet and disconnect the cable when not in use.
- If the hand massager feels hot to the touch (above 110°F/43°C) during charging, immediately disconnect the battery from the charger and stop charging.
- Place a Class D fire extinguisher nearby to prevent fire.
- Do not expose this unit to water or moisture.
Care, Maintenance and Cleaning Instructions
- Store the hand massager in a cool, dry place when not in use.
- Do not put this unit into any liquid.
- Keep away from all solvents and harsh cleaners.
- After use, wipe with a soft damp cloth with a non-abrasive cleaner.
**** At the end of its life, the device has to be separated from the other waste. Consign the device and all its components together to a center of electronical and electrotechnical waste recycling center, designated by your local authorities
Customer Service:
Email:orderwarranty@hotmail.com
Tel.: +1 6264203417(US) Mon-Fri 9:00-17:00(PST)
148 s 8th ave city of industry CA91746
MADE IN CHINA
Documents / Resources
|
Morelax M208 Hand Massager with Heat Compression and
Heating
[pdf] User Manual
M208 Hand Massager with Heat Compression and Heating, M208, Hand Massager with
Heat Compression and Heating, Massager with Heat Compression and Heating, Heat
Compression and Heating, Compression and Heating, Heating
---|---