ITC Wander Flex Light Installation Guide
- June 3, 2024
- ITC
Table of Contents
ITC Wander Flex Light
PARTS / TOOLS NEEDED
Safety Instructions
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Do not install any luminaire assembly closer than 6” from any combustible materials.
Installation Considerations For All Flexible Lighting Products
- Do not bend lighting more than necessary. Refer to page two for bend radius minimums.
- Only bend the LED ribbon in one natural direction, do not try to bend in an unnatural direction such as twisting.
Installation Considerations For HMTL Flexible Lighting
- Unroll the entire length of HMTL before installing.
- Start installation at the wire lead end.
- When installing the light on the mounting surface, make sure to push towards the wired end.
- Do not use any roller as that may cause damage to the LED circuit
INSTALLATION INSTRUCTIONS
- Determine installation location and drill a hole in the mounting surface
- Secure clips to mounting surface using #6 pan head screws (not provided). Clip spacing is dependant on application, when Sealant here going around curves clip spacing should be closer
- Feed the wires into the hole and apply application specific sealant around the hole and wires Sealant here
- Secure the light in the track by gently pushing into clips
- Follow the wiring diagram below to wire the light to your system
HMTL flexible lighting cannot be field cut. Field cutting the light will void the warranty. - Cont. Follow the wiring diagram below to wire the light to your system
ALWAYS INSTALL WIRE END FIRST
MINIMUM BEND RADIUS 
3030 Corporate Grove Dr. Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-
policy
DOC #: 710-00114 • Rev C • 08/20/20
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>