WiTouch Pro TENS Unit for Back Pain Relief User Guide

: June 3, 2024
: WiTouch

Table of Contents

WiTouch Pro TENS Unit for Back Pain Relief
Box Contents
INSTRUCTIONS MUST BE FOLLOWED. PLEASE DO NOT DISCARD
PAIRING INSTRUCTIONS
Download, install, & connect the WiTouch Pro App
Smartphone Pairing
Apply Gel Pads
Place on Your Back
Start a Treatment
Documents / Resources

WiTouch Pro TENS Unit for Back Pain Relief

WiTouch-Pro-TENS-Unit-for-Back-Pain-Relief-PRODUCT

IMPORTANT! Refer to the user manual for all Indications, Contraindications, Warnings, Precautions, Adverse Reactions, and directions. A detailed user manual with instructions for use is available in the WiTouch Pro App’s information tab and for download at hollywog.com/contact. A printed copy of the user manual can be requested by contacting Hollywog at info@hollywog.com

Box Contents

WiTouch-Pro-TENS-Unit-for-Back-Pain-Relief-
FIG-1

INSTRUCTIONS MUST BE FOLLOWED. PLEASE DO NOT DISCARD

For SETUP & Bluetooth

PAIRING INSTRUCTIONS

WiTouch-Pro-TENS-Unit-for-Back-Pain-Relief-
FIG-2

Scan the QR code with the camera on your smartphone or visit hollywog.com/setup

Download, install, & connect the WiTouch Pro App

The app is ONLY compatible with iOS 9.0 & above OR ANDROID 4.4 & above.

Download the WiTouch Pro App. The location must be ALLOWED.
Using the screwdriver provided, remove the battery cover and insert the AAA batteries.
Turn the device ON by pressing the ON/OFF button. The green LED will begin flashing, indicating the device is in standby mode.
Open your WiTouch Pro app
Click “OK” for iOS or “ALLOW” for Android to enable Bluetooth.
Press & HOLD the & intensity buttons at the same time until the LED stops flashing and remains solid green. Let go of the buttons. This should take approximately 3-4 seconds ONLY.
Click at the bottom of your screen.
Click “PAIR” for iOS devices. Click “OK” to pair for Android devices.
NOTE: If DEVICE NOT FOUND repeat steps 6-8.

Smartphone Pairing

WiTouch Pro can only be paired with one (1) smartphone at a time, or pairing will be lost.
IF YOUR DEVICE WILL STILL NOT PAIR… ensure Bluetooth is ON, and hold both PLUS (+) and MINUS (-) buttons for approximately 10 seconds (hold past the solid green). After approximately 10 seconds your LED will blink Yellow. Let go of the buttons. Bluetooth is now ON and ready to be paired (Refer to steps 6-8 above to follow pairing directions). If you see a green flash instead of yellow, REPEAT the approximate 10-second hold. The Yellow blink indicates Bluetooth is ON and ready to be paired.
Refer to Page 5 in the User Manual at hollywog.com/contact or call 423-305-7777.

Apply Gel Pads

Remove one (1) pair of gel pads, and separate the two gel pads.
Remove & discard the blue two-piece liner.
Adhere the exposed side of the gel pad to the black electrode surface on the back of your unit. To ensure good adhesion, rub firmly along the surface to remove large air bubbles. Repeat steps 2 & 3 for the second gel pad.

Place on Your Back

Remove the protective liners from the gel pads.
Align the center of the device over the spine and press the device to your back.

Start a Treatment

Within the App, choose one of the four treatment programs and press START. Your 30-minute Treatment will begin.
Adjust the intensity using and controls within the app, or on the device itself.

Using the WiTouch Pro WITHOUT a Smartphone

Follow the APPLY GEL PADS instructions above.
Turn the device ON by pressing the ON/OFF button. The green LED will begin flashing, indicating the device is in standby mode.
Follow the PLACE ON YOUR BACK instructions above.
To start the WiTouch Pro Exclusive Treatment Program press the (+) button. To increase the intensity, continue to press the (+) button one press at a time. Pressing the (-) button (one press at a time) will decrease the intensity. Further instructions are available on Page 7 of the User Manual @ hollywog.com/contact.

Hollywood

100 Cherokee Blvd. Chattanooga, TN 37405 USAwww.hollywog.com
® and © 2021 Hollywog, LLC. All rights reserved. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by Hollywog, LLC is under license. Other trademarks and trade names are those of their respective owners.
U.S. Patents 9,764,133, 8,972,016, D712,052, D716,958. International patents are pending. Made in the USA
LOCATION is used to determine the app’s language. Disable the location setting after the first successful pairing. 11S.1102A 04/30/2021

Documents / Resources

| WiTouch Pro TENS Unit for Back Pain Relief [pdf] User Guide
Pro TENS Unit for Back Pain Relief, Pro, TENS Unit for Back Pain Relief, TENS Unit, Back Pain Relief, Back Pain Relief Tens Unit
---|---