Illumination LED HBLE-FS SERIES LED Linear High Bay Instruction Manual
- June 3, 2024
- Illumination LED
Table of Contents
LED HBLE-FS SERIES LED Linear High Bay
Instruction Manual
Wiring Diagram
For dimming wires, use class 1 wiring methods. Cap dimming wires (separately)
if not used.
SAVE THESE INSTRUCTIONS
CAUTION:
- Read all instructions before starting installation.
- This product must be installed in accordance with the applicable installation codes by a qualified electrician familiar with the construction and operation of the product and the hazards involved.
- Disconnect power at circuit breaker of fuse before starting installation.
- To avoid injury, wear gloves during installation.
- To reduce the risk of electrical shock and product damage, do not install this luminaire during rain or other storms.
- Do not test luminaire using an electric generator before installation.
Instructions:
Standard Mounting
Chain Mount:
To suspend the highbay luminaire from chains, attach the enclosed v-hooks to
the holes on the end caps. Attach the chain to a secure, stationary structure,
and use the spring clips on the end to attach the chain to the v-hooks. Choose
the appropriate knock out, and wire the fixture in accordance with proper
code. (Figure 1)
Optional Mounting
Optional moutning kits sold separately
Cable Mount:
To suspend the highbay luminaire from cables, slide the button stop attached
to the end of the cable kit through the hole in the end cap. Then, slide the
rectangular plate installed on the cable through the same hole. Attach the
cable to a secure, stationary structure. Use the spring slide to adjust the
height. Choose the appropriate knockout, and wire the fixture in accordance
with proper code.
Surface Mount:
To surface mount the highbay luminaire, bolt the fixture brackets to the
ceiling or rail (Figure 1). Once the brackets have been property secured,
attach the luminaire using the screws provided (Figure 2). Choose the
appropriate knockout, and wire the fixture in accordance with proper code.
Motion Sensor/PIR Sensor (option
sold seperately):
To install motion/PIR sensor, first open the driver cover by removing the
screws (Figure 1). Using the knock out on the side cover, mount the sensor,
and make wire connections in accordance with code (Figure 2). Once the wiring
is complete, reattach the driver cover (Figure 3).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>