REMINGTON Power Series R2 User Manual
- June 7, 2024
- Remington
Table of Contents
POWER SERIES R2 USE & CARE MANUAL PLEASE READ PRIOR TO USE
To register your product go to www.remington-products.com.au www.remington.co.nz
2 YEAR WARRANTY
R2000AU
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be observed,
including the following. READ ALL INSTRUCTIONS BEFORE USING DANGER: As with
most electrical appliances, electrical parts are electrically live even when
the switch is off. For additional protection, the installation of a residual
current device (rcd) having a rated residual operating current not exceeding
30 mA is advisable in the electrical circuit supplying the bathroom. Ask your
installer for advice.
WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION AND FIRE OR INJURY TO
PERSONS
- The appliance should never be left unattended when plugged into a power outlet.
- This appliance should not be used by children or other persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- Never operate this appliance if it has a damaged cord or plug, if it is not working correctly, if it has been dropped or damaged, or dropped into water. If the supply cord or plug of the appliance is damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. It cannot be repaired. • Keep the cord away from heated surfaces.
- Use and store the product at a temperature between 0°C and 32°C.
- Do not use outdoors or where aerosol (spray) products are being used, or where oxygen is being administered.
- Do not use this appliance with damaged or broken tracks or cutters, as injury may occur.
- Do not plug or unplug the appliance with wet hands.
- For household use only.
- Do not place or store the appliance or power adaptor where it can fall or be knocked into a sink or bath.
- Do not place in or drop into water or any other liquid.
- If an appliance falls into water, “unplug it” immediately. Do not reach into the water.
- Unplug the power adaptor from the electrical outlet immediately after shaving.
- Do not use while bathing or in the shower.
- Unplug and switch off this appliance before cleaning it.
- Use this appliance only for its intended use as described in this manual.
- Do not use attachments not recommended by Remington.
- Never drop or insert any object into any opening of this appliance.
- Always store the power adaptor in a moisture-free location.
- Do not use on people who are asleep.
- Do not use an extension cord or a voltage converter with this appliance.
- Do not wrap the cord around the appliance.
Remington strongly recommends that an approved Safety Switch (residual current device) be installed to protect all bathroom power outlets. Ask an electrical contractor for advice.
SAVE THESE INSTRUCTIONS
R2000AU POWER SERIES R2
USE & CARE INSTRUCTION MANUAL
Thank you for purchasing your Remington® Power Series R2 rotary shaver. Inside
this manual, you will find tips on using and caring for your shaver.
KEY PARTS
1. On/Off Switch
2. Shaving Head
3. Head Release Button
4. Pop Up Trimmer (not shown)
5. Power Port (not shown)
Also Includes: • Head Guard • Cleaning Brush • Power Adaptor
ABOUT YOUR SHAVER
R2000AU SPECIFICATIONS
Power System| Corded
Voltage Type| Worldwide
Replacement Head & Cutters| SP-4141AH
Voltage Type: Worldwide Voltage – shaver automatically adapts to an
outlet the voltage between 100V and 240V
Note: Some countries will require the use of a plug adaptor that is not
included with your shaver.
SHAVING
Firmly insert the power cord into the power plug at the base of the shaver. When doing this for the first time the plugs may be tight at the pin connection points, proceed to insert the plug firmly until it is in place and will not disconnect when gently tugged.
- Switch the On/Off button to activate for shaving (Diagram A).
- Hold the shaver so that all the heads touch your face together (Diagram B). This allows the shaver to work the way it was designed for the closest shave and minimum wear. Avoid holding the shaver at an angle so that only one head touches the skin. Use short, circular strokes. Use your free hand to stretch your skin. This encourages your whiskers to stand out, making it easier for them to enter the cutting chamber. Never press hard when shaving. Pressing hard only flattens the whiskers, which makes it harder for them to enter the cutting chamber. It will also cause the cutting surface to wear out more quickly.
- Switch the On/Off button to turn the shaver off (Diagram A).
SHAVING TIPS
- Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be present from sleeping.
- Always hold the shaver at a right angle to the skin so that all three heads are touching the skin with equal pressure.
- Stretch the skin with the freehand so hairs stand upright, making it easier for them to enter the cutting chamber.
- Use moderate to slow, circular stroking movement.
- The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
- Do not press hard against the skin to avoid skin irritation and/or damage to the rotary heads.
- As with every shaver, your shave will improve over time. Allow up to four weeks of daily shaving to develop an effective shaving style and for your skin to adjust to the new shaver. The adaptation period might take a little longer if your skin is sensitive, if you are switching from a different method of shaving, or if you alternate between shaving methods.
TRIMMING
Pop-up Trimmer:
1. Push the trimmer release button to engage the trimmer.
2. Trim long, difficult hairs and sideburns.
3. Close the trimmer by pressing down.
Note: Lubricate teeth with oil every 6 months.
CLEANING & MAINTENANCE
Daily Cleaning
1. Open the shaver head by pressing the release button on the front of the
shaver (Fig. A) and flipping open the head away from the body of the shaver
(Fig. B).
2. Tap out excess hair shavings.
3. Close the head assembly (Fig. C).
Monthly Cleaning
1. Perform the daily cleaning steps 1 and 2.
2. Remove the cover from the hair pocket assembly. (Diagram D) Place the body
of the shaver aside to ensure that it will not get wet.
3. Place a drop of liquid soap on each cutter. (Diagram E)
4. Brush the soap around vigorously using the supplied cleaning brush.
(Diagram F)
5. Release the inner cutter carrier by rotating the locking arms
counterclockwise. (Diagram G)
6. Remove the inner cutter carrier away from the cutters. (Diagram H)
7. Remove the cutters. (Diagram I)
8. Thoroughly brush any hair off of the inner and outer cutters (Diagram J)
and rinse away any soap and debris from the inner and outer cutters. “(Diagram
K)
9. Replace the inner cutters. (Diagram L)
10. Place the inner cutter carrier back into position and lock it into place
by rotating the locking arms clockwise until they snap into place. (Diagram M)
11. Lubricate each cutter with household oil.
12. Close the head assembly. (Diagram C)
MONEY BACK OFFER – AUSTRALIA / NEW ZEALAND ONLY
If within 60 days you are not fully satisfied with your Remington® shaver,
just return the shaver with this completed coupon and a copy of your
Australian/New Zealand purchase receipt to Remington®. In return, we will send
you a cheque for the full purchase price of the shaver.
Please allow 6-8 weeks for your cheque to arrive.
Name:
Address:__
City:__
State:____ Postcode:_____ DOB:__
Contact No: Area Code:__ Ph:__
Product Model number:__
Is this the first Remington shaver you have owned/purchased? Yes__
No__
Why are you returning this shaver?
Skin Irritation__ Shave is not close enough__ Prefer a
rotary/foil shaver
Other:__
Spectrum Brands Australia Pty Ltd
Locked Bag 3004
Braeside, VIC 3195
AUSTRALIA
Customer service in Australia: 1800 623 118
E-mail: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
PO Box 9817
Newmarket, Auckland 1149
NEW ZEALAND
Customer service in New Zealand: 0800 736 776
E-mail: info@remington.co.nz
Website: www.remington.co.nz
WARNING:
- Only the detachable shaving head can be rinsed with water.
- DO NOT rinse the hand-held shaver underwater as damage will occur.
REPLACING THE HEAD & CUTTERS
Please refer to the FEATURE table on page 5 of this manual that lists the correct replacement part number for your shaver. It is very important to replace your head and cutters when necessary to ensure a close, comfortable shave without irritation. We recommend they be replaced every 12 months. Here are some signs of head and cutter wear, indicating that replacement is needed:
- Irritation: As the heads get excessively worn you may experience some skin irritation. This would be especially noticeable when you apply moisturizing lotion.
- Pulling: When the cutters wear you may feel a sense of pulling and a loss of closeness when you shave. This is an indication that it is time to replace your heads and cutters.
Replacement heads & cutters may be obtained from your local retailer, or directly from Remington ®. Simply fill out the enclosed accessory order form – refer to pages 8 & 9, or alternatively, your order can be processed over the phone via the Remington ® Service Hotline.
We suggest you use local waste management centers to recycle this product at end of life.
This product is not suitable for use in a bath or shower.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law means the Australian consumer law set out in
Schedule 2 to the Competition and Consumer Act 2010;
CGA means the New Zealand Consumer Guarantees Act 1993;
Goods mean the product or equipment which was accompanied by this
warranty and purchased in Australia or New Zealand, as the case may be;
Manufacturer, We or us means:
- for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd ACN, 007 070 573; or
- for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited, as the case may be, contact details as set out at the end of this warranty;
Supplier means the authorized distributor or retailer of the Goods that
sold you the Goods in Australia or in New Zealand; and
You mean you, the original end-user purchaser of the Goods.
-
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
-
The benefits provided by this Warranty are in addition to all other rights and remedies in respect of the Goods which the consumer has under either the Australian Consumer Law or the CGA. The original purchaser of the Goods is provided with the following Warranty subject to the Warranty Conditions:
-
We warrant the Goods for all parts defective in workmanship or materials for the period of two (2) years from the date of purchase (Warranty Period). If the Goods prove defective within the Warranty Period by reason of improper workmanship or material, we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions -
The Goods must be used in accordance with the manufacturer’s instructions. This Warranty does not apply should the defect in or failure of the Goods be attributable to misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of the user. As far as the law permits, the manufacturer does not accept liability for any direct or consequential loss, damage or other expense caused by or arising out of any failure to use the Goods in accordance with the manufacturer’s instructions.
-
Consumable parts (such as shaver heads, cutters and foils) of the Goods are included under this Warranty only where there is a defect in workmanship or materials used.
-
The warranty granted under clause 3 is limited to repair or replacement only.
-
Any parts of the Goods replaced during repairs or any product replaced remain the property of the manufacturer. In the event of the Goods being replaced during the Warranty Period, the warranty on the replacement Goods will expire on the same date as for the Warranty Period on the original Goods which are replaced.
-
In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid freight within the Warranty Period accompanied with (i) the legible and unmodified original proof of purchase, which clearly indicates the name and address of the Supplier, the date and place of purchase, the product name or other product serial number and (ii) this warranty. -
This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Goods have been serviced or otherwise repaired by a person not authorized to do so by us or where non-approved replaced parts are used. -
The Goods are designed for domestic use only. A limited 90-day Warranty applies to any industrial or commercial use of the Goods. The Goods must be connected to the electrical voltage requirements as specified in the rating label located on the Goods.
-
This warranty does not cover the cost of claiming under the warranty or transport of the Goods to and from the Supplier or us.
-
This warranty is only valid and enforceable in Australia against Spectrum Brands Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Locked Bag 3004
Braeside, VIC 3195
AUSTRALIA
Customer service in Australia: 1800 623 118
E-mail: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
PO Box 9817
Newmarket, Auckland 1149
NEW ZEALAND
Customer service in New Zealand: 0800 736 776
E-mail: info@remington.co.nz
Website: www.remington.co.nz
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>