FINIVE Refrigerator Water Filter User Manual

Refrigerator Water Filter
USER’S MANUAL

FIN-15
REPLACES FILTERS:
LG LT700P
KENMORE 9690

PART 1

FINE OVERVIEW

FINE is a top-quality brand of water filter, our manufacturer is one of only two companies’ export filters that have passed NSF certification, we have top production technology and professional machine, adopt the better materials into the filters for great filtration effect.

1. Adopt Sri Lanka High-quality activated carbon, provide better effect of filtration and environment-friendly and resource-efficient.
2. Filter shell plastic is made of high purity polyethylene from Germany, lighter and stable.
3. The glue comes from LG in Korea, which ensures that the size of each honeycomb hole is uniform for ensuring the filtering effect.

PART 2

INSTALLATION INSTRUCTIONS

Removing the Filter
If you are replacing the filter, first press the push button to open the water filter cover, pull the old water filter downward and turn it counter-clockwise to pull it out. Make sure to rotate the filter down completely before pulling it out of the manifold hole.

ATTENTION!
Please remember to prepare a rag to absorb water leaks when removing the old filter.

INSTALLING THE FILTER IN A BOTTOM FREEZER REFRIGERATOR

1. Remove the top shelf. If the top shelf, which is located below the water filter, is in the highest position,it will need to be removed.
   This can be done in two simple steps:
   

2. Press the PUSH button to open the water filter cover.
   NOTE: Please remember to prepare a rag to absorb water leaks when removing the old filter.
   

3. Remove old water filter.
   Pull the old water filter downward and turn it counter-clockwise to pull it out. Make sure to rotate the filter down completely before pulling it out of the manifold hole.
   

4. Install new water filter.
   Take a new water filter out of its packaging and remove the protective cover from the o-rings.
   Apply the month and year sticker to the new cartridge to remind you to replace the filter in 3-6 months.
   With the filter tats in the horizontal position, push the new filter into the manifold hole, rotate it up into place, and close the cover.
   

5. Remove trapped air.
   Now that the filter is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather than dispensing continuously.
   If your model is equipped with a water filter indicator on the display, press and hold the FILTER button or RESET button for approximately 5 seconds to reset the filter indicator.

PART 3

WARNING!

To reduce the risk associated with choking, do not allow children under 3 years of age to have access to small parts during the installation
of this product.

NOTICE
To reduce the risk associated with property damage due to water leakage:

1. Read and follow use instructions before installation and use of this system.

2.  Installation and use must comply with all state and local plumbing codes.

3. Do not install if water pressure exceeds 100 psi (6.8 bar). If your water pressure exceeds 60 psi (4.1 bar), you must install a pressure-limiting valve.
   Contact a plumbing professional if you are uncertain about how to check your water pressure.

4. Water hammer conditions exist you must install a water hammer arrester. Contact a plumbing professional if you are uncertain how to check for this condition.

5. Do not install on hot water supply lines. The maximum operating water temperature of this filter system is 100º F (38º C).

6. Protect filter from freezing. Drain filter when temperatures drop below 33ºF (0.6ºC).

7. The disposable filter cartridge should be replaced every 3-6 months at the rated capacity, or sooner if a noticeable reduction in flow rate occurs.

Compatible Model:
LT700P, ADQ36006101, ADQ36006101-S, ADQ36006101S,  ADQ36006102, ADQ36006102-S, DQ36006102S,048231783705, 9690, 46-9690

PART 4

FQAS

Q: The water is coming out dirty/gray afer I installed the filter. Is this normal?
A: Yes that is normal. There is a carbon block inside the filter and sometimes during shipping, the filter gets knocked around and some of
that carbon gets loose. If you drain 2-3 gallons, the water will become clear

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>