My JetScrub Pet has no spray | Support
- June 7, 2024
- Bissell
Table of Contents
*The trigger on handle must be depressed to produce spray
-
Clean water tank on back of machine should be full
-
Remove tank by pulling up and inspect it for any cracks or leaks
- If tank is cracked or leaking, a replacement should be ordered
-
With your water tank removed, check for damage on cap
- If cap is damaged, a replacement should be ordered
-
Firmly push clean water tank back on machine
- It should click into place
-
Plug in machine
-
Hold spray trigger down for 10-15 seconds to prime and test for spray
- You should see solution bubbling under nozzle
-
Select clean shot button and test for spray from clean shot nozzle
-
If still no spray, unplug machine
-
Remove nozzle by pulling up on both sides
-
Check for clogs in spray tips on foot of machine
- Probe spray tips with a paperclip to clear away any clogs
-
Before reattaching nozzle, check for spray in spray tips
- Plug machine in and push express cleaning mode
- Depress trigger, water should flow from spray tips
-
If water flows from spray tips, turn machine off and unplug
- Reattach nozzle by lining up tabs on the front edges of the foot – push the window into place until a click is audible
-
Depress trigger to test for spray
- If spray came out of spray tips, but not nozzle, nozzle should be replaced
-
If there was no spray from the spray tips, Contact Us
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No