My BARKBATH™ Dual Use has Low/No Suction | Support
- June 7, 2024
- Bissell
Table of Contents
-
Remove dirty water tank by pulling up on top of it
-
Empty dirty water tank by unscrewing the bottom of tank and removing float
-
Rinse float with warm water and make sure float can freely move up and down
- If float cannot move freely, a replacement should be ordered
-
Put float back into dirty water tank and screw gray ring around bottom of tank to secure float into place
-
Set dirty water tank aside
-
Clear any debris from opening on motor-duct located on machine under dirty water tank
-
With machine turned on, check for suction at motor-duct
- If no suction, Contact Us
-
If there is suction coming from motor-duct, but no suction coming from the tool, continue troubleshooting
-
Remove top of suction nozzle and clear it of any hair or debris
-
Clear any debris from the end of tool
-
Place top of suction nozzle back onto tool and test for suction
-
If still no suction, Contact Us
-
Recipient Email
-
Your Email
Your Name
Was this answer helpful?
Yes
No