ITC 69237 Hardtop Light Instruction Manual
- June 3, 2024
- ITC
Table of Contents
ITC 69237 Hardtop Light Instruction Manual
PARTS/TOOLS NEEDED:
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND
SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- It is recommended that fuse protection be added to the positive (+) input.
-
Remove bezel and drill a hole in the mounting surface with a 3-5/8″ hole saw.
-
Wire the light following the wiring diagrams below.
If using a two wire version a standard switch can be used. The light should be turned off and on to cycle through the colors. If the light is off for more than 30 seconds it will restart the cycle.
If using a three wire version, a three position switch will be required.
-
Install screws into flange and tighten to mounting surface. Turn bezel clockwise to replace.
3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return- policy Rev B · 07/20/16
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>