MLA Knightsbridge 13A Smart 2G Switched Socket User Guide
- June 7, 2024
- MLA
Table of Contents
MLA Knightsbridge 13A Smart 2G Switched Socket
USER GUIDE
Download the SmartKnight App
On Google Play (AndroidTM) or App Store® (Apple®). Open the app, tap
“Register” and follow the on-screen instructions.
Add Device (2.4 GHz only)
To add a device tap the “+” on top right corner, select the product category
and follow the on-screen instructions.
Enjoy
Enjoy your connected product. For more in-depth instructions, please see
section titled “Wi-Fi Control” in this leaflet.
Setting up Voice Assistants
Enable the “SmartKnight” skill in either voice assistant and follow the app instructions to control your device(s) with your voice. Visit http://www.mlaccessories.co.uk for further assistance
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: SN9KW / CU9KW.
SAFETY
- This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
- Please isolate mains prior to installation or maintenance
- Check the total load on the circuit (including when this product is fitted) does not exceed the rating of the circuit cable, fuse or circuit breaker
- Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
- Do not overload this accessory or subject it to conditions outside its rating
- This product is Class I and must be earthed
- This product is IP20 rated
INSTALLATION
- Always ensure the wall surface is flat and smooth for optimum installation
- Provide power to the required point of installation
- Connect to the mains supply ensuring the correct polarity is observed: L – Live (Brown), E – Earth (Green/Yellow), N – Neutral (Blue), see Fig. 1
- Always ensure the wall surface is flat and smooth for optimum installation
- Provide power to the required point of installation
- Connect to the mains supply ensuring the correct polarity is observed: L – Live (Brown), E – Earth (Green/Yellow), N – Neutral (Blue), see Fig. 1
WI-FI CONTROL
Note – Please note that these instructions were correct at the time of printing, for the latest version please visit our website www.mlaccessories.co.uk
- Download the SmartKnight app from Google Play Store or the Apple App Store
- Once the app has downloaded, open the app, tap “Register” then follow the on screen instructions
- To add a socket to the app, switch on the power and tap “+” on the top right corner
- Select “Socket (Wi-Fi)”
- If the indicator is flashing rapidly, skip the reset procedure and tap “Confirm the indicator is flashing rapidly”. If the indicator is not flashing, follow the on-screen instructions to reset
- Connect to the desired Wi-Fi network, tap “Confirm” and the app will start searching for devices. Please note that only 2.4 GHz networks are supported and make sure that your device is connected to the same Wi-Fi network
- After the socket has successfully been added to the app, it can be named and added to a room. After naming the socket, tap “Done”
Note – Please note that the indicators on this product will flash red when the Wi-Fi connection is not strong enough.
WARNING
This product must be disconnected from the circuit if subjected to any high
voltage or insulation resistance testing. Irreparable damage will occur if
this instruction is not followed.
GENERAL
This product should be recycled in the correct manner when it reaches the end
of its life. Check local authorities for where facilities exist. Clean with a
soft dry cloth only, do not use aggressive cleaning products or solvents which
may damage the product.
WARRANTY
This product has a warranty of 2 years from date of purchase. Failure to
install this product in accordance with the current edition of the IEE Wiring
Regulations (BS7671), improper use, or removal of the batch code will
invalidate the warranty. If this product should fail within its warranty
period it should be returned to the place of purchase for a free of charge
replacement. ML Accessories does not accept responsibility for any
installation costs associated with the replacement product. Your statutory
rights are not affected. ML Accessories reserve the right to alter product
specification without prior notice.
ML Accessories Limited LU5 4LT
www.mlaccessories.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>