BELNICK Leather Executive Swivel Chair Instructions
- June 7, 2024
- BELNICK
Table of Contents
BELNICK Leather Executive Swivel Chair
ASSEMBLY INSTRUCTIONS
Before You Begin
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in
personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to
product or components may result.
Warning:
CHOKING HAZARD – Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
PARTS
**STEP 1
**
**STEP 2
**
**STEP 3
**
STEP 4
Open the Velcro on both sides of seat first, then place the Back Cushion
(7) on the Seat Cushion (6) ,and use 2 bolts (10) to attach to
the lower screw holes on Seat Cushion (6) (see diagram).
*Note: DO NOT FULLY TIGHTEN BOLTS
STEP 5
Push the Back Cushion (7) up to a vertical position and attached the
Seat Cushion (6) to by using 2 bolts (10) , then to cover the Velcro
back.
*Note: Tighten the bolts completely
STEP 6
STEP 7
Documents / Resources
|
BELNICK Leather Executive Swivel
Chair
[pdf] Instructions
BELNICK, Leather Executive Swivel Chair
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>