thomann BP 108 A active 2-way speaker User Manual

BP 108 A
active 2-way speaker
user manual

General information

his user manual contains important information on the safe operation of the device. Read and follow all safety notes and all instructions. Save this manual for future reference. Make sure that it is available to all persons using this device. If you sell the device to another user, be sure that they also receive this manual.
Our products and user manuals are subject to a process of continuous development. We, therefore, reserve the right to make changes without notice. Please refer to the latest version of the user manual which is ready for download under www.thomann.de.

Further information

On our website (www.thomann.de) you will find lots of further information and details on the following points:

topics of
interest for you quickly
Online guides| Our online guides provide detailed information on technical basics
and terms.
Personal consultation| For a personal consultation please contact our technical hotline.
Service| If you have any problems with the device the customer service will
gladly assist you.

Notational conventions

This manual uses the following notational conventions:

Letterings| The letterings for connectors and controls are marked by square brackets and italics.
Examples: [VOLUME] control, [Mono] button.
---|---
Displays| Texts and values displayed on the device are marked by quotation marks and italics.
Examples: ‘24ch’ , ‘OFF’ .

Symbols and signal words

In this section, you will find an overview of the meaning of symbols and signal words that are used in this manual.

immediately dangerous situation that will result in death or
serious injury if it is not avoided.
WARNING!| This combination of symbol and signal word indicates a pos‐
a possible dangerous situation that can result in death or serious
injury if it is not avoided.
CAUTION!| This combination of symbol and signal word indicates a pos‐
a possible dangerous situation that can result in minor injury if it
is not avoided.
NOTICE!| This combination of symbol and signal word indicates a pos‐
a possible dangerous situation that can result in material and
environmental damage if it is not avoided.
Warning signs| Type of danger
| Warning – high-voltage.
Warning signs| Type of danger
---|---
| Warning – danger zone.

Safety instructions

Intended use
This device is designed for sound reinforcement. Use the device only as described in this user manual. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use.
This device may be used only by persons with sufficient physical, sensorial, and intellectual abilities and having corresponding knowledge and experience. Other persons may use this device only if they are supervised or instructed by a person who is responsible for their safety.
DANGER!
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts (e.g. knobs or the like) from the unit. They could swallow the pieces and choke! Never let children unattended use electrical devices.
DANGER!
Electric shock caused by high voltages inside
Within the device, there are areas where high voltages may be present. Never remove any covers. There are no user-serviceable parts inside. Do not use the device if covers, protectors or optical components are missing or damaged.

DANGER!
Electric shock caused by short-circuit
Always use proper ready-made insulated mains cabling (power cord) with a protective contact plug. Do not modify the mains cable or the plug. Failure to do so could result in electric shock/death or fire. If in doubt, seek advice from a registered electrician.
CAUTION!
Possible hearing damage
The device can produce volume levels that may cause temporary or permanent hearing impairment. Over an extended period of time, even levels that seem to be uncritical can cause hearing damage. Decrease the volume level immediately if you experience ringing in your ears or hearing impairment. If this is not possible, keep a greater distance or use sufficient ear protectors.
WARNING!
Incorrect handling of lithium batteries can result in injury
In the event of a short circuit, overheating or mechanical damage, lithium batteries can cause severe injuries. Follow the advice on the correct handling of lithium batteries in the present section.
NOTICE!
Risk of fire
Do not block areas of ventilation. Do not install the device near any direct heat source. Keep the device away from naked flames.

NOTICE!
Risk of fire due to the incorrect polarity
Incorrectly inserted batteries may destroy the device or the batteries. Ensure that proper polarity is observed when inserting batteries.
NOTICE!
Operating conditions
This device has been designed for indoor use only. To prevent damage, never expose the device to any liquid or moisture. Avoid direct sunlight, heavy dirt, and strong vibrations. Only operate the device within the ambient conditions specified in the chapter ‘Technical specifications’ of this user manual. Avoid heavy temperature fluctuations and do not switch the device on immediately after it was exposed to temperature fluctuations (for example after transport at low outside temperatures). Dust and dirt inside can damage the unit. When operated in harmful ambient conditions (dust, smoke, nicotine, fog, etc.), the unit should be maintained by qualified service personnel at regular intervals to prevent overheating and other malfunction.
NOTICE!
Possible damage by leaking batterie s
Leaking batteries can cause permanent damage to the device. Take batteries out of the device if it is not going to be used for a longer period.

NOTICE!
Possible damage to lithium-ion batteries through incorrect storage
By deep discharge, lithium-ion batteries can be permanently damaged or lose some of their capacity. Before long breaks, charge the batteries to around 50 % of their capacity and then switch off the device. Store the device at room temperature or cooler in an envi‐ content as dry as possible. If the batteries are stored for a longer period, recharge them to 50 % every three months. Fully charge the batteries only shortly before use at room temperature.
NOTICE!
Possible staining
The plasticizer contained in the rubber feet of this product may possibly react with the coating of your parquet, linoleum, laminate or PVC floor and after some time cause permanent dark stains. In case of doubt, do not put the rubber feet directly on the floor, but use felt-pad floor protectors or a carpet.

Features

The mobile PA system is characterized by the following features:

• 2-way active speaker box for PA and DJ application
• Maximum output power: 60 W
•  8″ woofer
•  1″ compression driver
• 2-band equalizer
• Built-in media player with display, SD/MMC card slot, USB port and Bluetooth receiver
•  2 × MIC input (1/4″ phone socket, unbalanced)
• 1 × RCA socket pair
• Solid plastic housing with pole mount and handles
•  Includes power adapter

Starting up

Unpack and check carefully there is no transportation damage before using the unit. Keep the equipment packaging. To fully protect the product against vibration, dust and moisture during transportation or storage use the original packaging or your own packaging material suitable for transport or storage, respectively.
Create all connections while the device is off. Use the shortest possible high-quality cables for all connections. Take care when running the cables to prevent tripping hazards.

NOTICE!
Possible property damage by magnetic fields
Loudspeakers produce a static magnetic field. Therefore, maintain an appropriate distance to devices that can be adversely affected or damaged by an external magnetic field.
The unit can be mounted on a stand or set up on the floor or a sufficiently sized and stable surface, e.g. a wall bracket.
NOTICE!
Use of stands
When mounting the device onto a stand, ensure that the stand is in a safe and stable position and that the weight of the device does not exceed the maximum permissible load capacity of the stand.

Dealing with lithium batteries

WARNING!
Incorrect handling of lithium batteries can result in injury
In the event of a short circuit, overheating or mechanical damage, lithium batteries can cause severe injuries.
Follow the advice on the correct handling of lithium batteries in the present section.

When handled correctly and appropriately lithium batteries pose no risk.
Store lithium batteries in a cool, dry place, ideally in the original packaging.
Store lithium batteries away from heat sources (e.g. radiators or sunlight). Lithium batteries are hermetically sealed. Never attempt to open a lithium battery.
If the battery housing is damaged small amounts of the electrolyte may leak out. If this should happen, seal the lithium battery in airtight packaging and wipe up the traces of electrolyte using absorbent paper towels. You must wear protective rubber gloves when doing so. Clean your hands and the affected surface thoroughly with cold water.
Never attempt to recharge non-rechargeable lithium batteries. When charging lithium batteries you must use a suitable charging device intended for the purpose.
Before disposing of the device remove the lithium batteries. Protect used lithium batteries against potential short circuits, e.g. by covering the poles with adhesive tape.
Only use powder extinguishers or other suitable extinguishing agents to extinguish a burning lithium battery.

Connections and controls

Hold down the button to decrease the volume.
If you press the button briefly, it has a different function depending on the mode:
USB / SD / Bluetooth: Skip back, Line: no function

Depending on the mode, this button has a different function:
USB / SD / Bluetooth: Pause playback, Line: Mute
| Hold down the button to increase the volume.
If you press the button briefly, it has a different function depending on the mode:
USB / SD / Bluetooth: Skip ahead, Line: no function
---|---
[M]

Button for selecting the mode (USB / SD / Bluetooth, line input).

5| SD / MMC card slot
6| VOLUME]

Use this control to adjust the volume of your microphone, instrument, or another audio source.

7| BASS] Use this control to adjust the low frequencies of your microphone, instrument, or another audio source.
8| [TREBLE] Use this control to adjust the high frequencies of your microphone, instrument, or another audio source.
9| [M.ECHO]

Use this control to adjust the echo effect of your microphone or instrument.

---|---
10| [M.VOL] Use this control to adjust the volume of your microphone or instrument.
11| Connection socket for a power supply 15 V DC 1 A
12| Main switch to turn the device on and off.
13| LEDs
Blue: Lights up when the device is turned on
Red: Lights up when the device is connected to the mains or being charged
Green: Lights when the battery is fully charged
14| 1/4″ phone socket to connect the microphone or instrument.
15| RCA input sockets for connecting an external audio device.

Playback via Bluetooth

You can play music wirelessly from mobile Bluetooth devices such as smartphones, tablets, or laptops via the built-in Bluetooth receiver of the device. Observe the user’s guide of your Blue‐ tooth device. Place the Bluetooth device near the box and turn it on.
Press [MODE] repeatedly until the display shows ‘BT’. After a few seconds, your Bluetooth device will be detected (name ‘BP-108A’ ) and the display shows ‘BT’ permanently.
You can then play the music files stored on the Bluetooth device. Use the buttons of the built-in player for control.

Technical specifications

Inputs| 1 × RCA socket pair, stereo

2 × 1/4″ phone socket, unbalanced

---|---
Speaker| Two-way system with 1″ compression driver and 8″ woofer
Max. sound pressure level| 109 dB
Frequency range| 75 Hz … 18 kHz
Storage media| SD card, USB devices
Playback formats| MP3, WAV
Bluetooth®| Frequency of operation| 2.402 GHz … 2.480 GHz
Max. transmission power| +2 dBm
Standard| Version 5.0
Name| BP-108A
Output power| RMS: 15 W

Peak: 60 W

Supply voltage| External power adapter, 100 – 240 V  50/60 Hz
Operating voltage| 15 V  / 1000 mA, center positive
Mounting option| Standing or on a tripod
Dimensions (W × H × D)| 245 mm × 390 mm × 195 mm
Weight| 4.6 kg
Ambient conditions| Temperature range| –5 °C…45 °C
| relative humidity| 20 %…80 % (non condensing)

Further information

Plug and connection assignment

Introduction

This chapter will help you select the right cables and plugs to connect your valuable equipment in such a way that a perfect sound experience is ensured.
Please note these devices, because especially in ‘Sound & Light’ caution is indicated: Even if a plug fits into the socket, an incorrect connection may result in a destroyed power amp, a short circuit or ‘just’ in poor transmission quality!

Balanced and unbalanced trans-mission

Unbalanced transmission is mainly used in semi-professional environments and in hifi use.
Instrument cables with two conductors (one core plus shielding) are typical representatives of the unbalanced transmission. One conductor is ground and hielding while the signal is transmitted through the core.
Unbalanced transmission is susceptible to electromagnetic interference, especially at low levels, such as microphone signals and when using long cables.
In a professional environment, therefore, balanced transmission is preferred, because this enables an undisturbed transmission of signals over long distances. In addition to the conductors ‘Ground’ and ‘Signal’, in a balanced transmission, a second core is added. This also transfers the signal but is phase-shifted by 180°.
Since the interference affects both cores equally, by subtracting the phase- shifted signals, the interfering signal is completely neutralized. The result is a pure signal without any noise inter‐ ference.

Plug and connection assignment

1/4″ TS phone plug (mono, unbalanced)

RCA connection

Drawing and table indicate the pin assignment of an RCA plug.

Cleaning

Device components

Clean the device components that are accessible from the outside regularly. The cleaning frequency depends on the operating environment: damp, smoky or particularly dirty environments can cause a greater accumulation of dirt on the device components.

•  Clean with a dry soft cloth.
• Stubborn dirt can be removed with a slightly dampened cloth.
• Never use solvents or alcohol for cleaning.

Protecting the environment

Disposal of the packaging material

For the packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling.
Ensure that plastic bags, packaging, etc. are properly disposed of.
Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the notes and markings on the packaging.

Disposal of batteries

Batteries do contain some hazardous chemicals so they should not be thrown away with normal household waste. They should be returned to the manufacturer for disposal or recycled elsewhere in accordance with your local regulations.
Dispose of lithium batteries only in discharged condition. Remove lithium batteries from the device before disposal. Protect used lithium batteries against potential short circuits, e.g. by covering the poles with adhesive tape. Dispose of the built-in lithium batteries together with the device. Please check for an appropriate reception facility.

Disposal of your old device

This product is subject to the European Waste Electrical and Electronic Equipment Directive (WEEE) in its currently valid version. Do not dispose with your normal household waste.
Dispose of this device through an approved waste disposal firm or through your local waste facility. When discarding the device, comply with the rules and regulations that apply in your country. If in doubt, consult your local waste disposal facility.

Musikhaus Thomann · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de

Musikhaus Thomann
Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Telephone: +49 (0) 9546 9223-0
E-mail: info@thomann.de
Internet: www.thomann.de
05.07.2021, ID: 471746 (V2)

References

• Buy musical instruments online from the market leader – Thomann United States

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>