ProSeal PS-VS005 Food Vacuum Sealer User Manual
- June 7, 2024
- ProSeal
Table of Contents
Vacuum Sealer
User Manual
Model: PS-VSOO5
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
Please read and fully understand all instructions and warnings prior to
using this machine. Your safety is very important!
IMPORTANT SAFEGUARDS
- Read the instructions carefully.
- Do not allow the appliance to be used as a toy.
- This appliance should not be operated by children.
- Do not operate the appliance with a damaged power cord or plug.
- Do not use the appliance on a wet or hot surface, or near a heat source.
- Always use the appliance on a level surface.
- Do not immerse any part of the appliance, power cord, or plug into water or any other liquid.
- To disconnect. unplug the power cord from the electrical outlet. Do not disconnect by pulling on the cord. Always unplug the appliance before cleaning and when not in use.
- Do not operate the appliance if it malfunctions or is in any way damaged. If the cord or the machine is damaged, please return it to the manufacturer for proper service, replacement, or repair.
- Close supervision is required when this product is used near children.
- The appliance is not for commercial use. If sealing more than 20 bags continuously, wait at least 25 minutes before resuming use of your appliance.
- Keep the upper lid of the appliance unlocked when not in use.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY
Do not attempt to service this product. Service should be performed by an
authorized service representative.
A short power supply cord is provided to reduce the risk resulting from
becoming tangled in or tripping over a longer cord. Extension cords are not
prohibited from being used when care is exercised in their use. When an
extension cord is used. the marked electrical rating of the extension cord
shall be no less than the marked electrical rating of the appliance,
The longer cord must be arranged so that it does not drape over the counter-
top or tabletop where It is capable of being tripped over, snagged, or pulled
on unintentionally.
especially by children.
POLARIZED PLUG
WARNING This product is equipped with a polarized plug (one blade is
wider than the other blade) to reduce the risk of electrical shock. This is a
safety feature.
The plug will fit into a polarized outlet only one way. If you are unable to
insert the plug into the electrical outlet. try reversing the plug. If the
plug still does not fit. contact a qualified electrician. Never use the plug
with an extension cord unless you can fully insert the plug into the extension
cord, Do not alter the plug.
Do not attempt to defeat the safety purpose of the polarized plug,
SAVE THESE INSTRUCTIONS
VACUUM SEALING GUIDELINES
FOOD STORAGE & SAFETY
For best results in extending the life of foods, it is important to vacuum
package foods that are fresh. Once food has begun to deteriorate, vacuum
packaging may only slow the deterioration process.
Vacuum sealing cannot prevent the growth of mold. Other disease-causing
microorganisms can still grow in low oxygen environments and may require
further measures to be eliminated.
IMPORTANT: Vacuum packaging is NOT a substitute for refrigeration or
freezing. Any perishable foods that require refrigeration must still be
refrigerated or frozen after vacuum packaging.
FOOD PREPARATION HINTS AND TIPS FOR AIR-TIGHT VACUUM SEALING
Cooking. Thawing and Reheating: Simmering in a vacuum bag helps food retain
its flavor and it helps with the dean up as well
No dirty saucepans! When reheating foods in the microwave using your vacuum
bags, always puncture open the bag to allow hot air to escape. You can also
reheat foods in the vacuum bags by placing them in water at a low simmer below
170°F (75°C).
IMPORTANT: Always thaw foods in either a refrigerator or microwave — do
not thaw perishable foods at corn temperature.
PREPARATION HINTS FOR MEAT AND FISH :
Try pre-freezing meats and fish for 1-2 hours before vacuum packaging. This
helps retain the juices and shape. and provides for a better seal.
If you can’t, place a folded paper towel between the food and the top of the
bag, but below the seal area. Leave the paper towel in the bag to absorb
excess moisture and juices during the vacuum packaging process.
PREPARATION HINTS FOR CHEESES:
Vacuum package cheeses after each use. If you make your bag just a little
longer than needed, you can re-seal the bag after each use.
IMPORTANT: Due to the risk of anaerobic bacteria. soft cheeses should
never be vacuum packaged.
PREPARATION GUIDELINES FOR VEGETABLES :
Blanching is a process that should be done before vacuum packaging
vegetables. This process stops the enzyme action that could lead to loss of
flavor, color, and texture. To blanch vegetables, place them in simmering
water or in a microwave until they are cooked, but still crisp. Blanching
times can range from 1 to 2 minutes for leafy greens and peas, 3 to 4 minutes
for snap peas, sliced zucchini, or broccoli, give your carrots about 5
minutes, and 7 to 11 minutes for corn on the cob. After blanching, immerse the
vegetables in cold water to stop the cooking process.
NOTE: All vegetables (including broccoli, Brussels sprouts, cabbage.
cauliflower, kale, turnips, etc.) naturally emit gases, during storage.
Therefore, after blanching, it’s best if they’re stored in the freezer.
More on Vegetables :
Vegetables are a great candidate for portion control. When storing
vegetables. try pre-freezing them for 1 to 2 hours. then separate them Into
meal portions within your vacuum bags. Alter the have been vacuum packaged,
return thorn to the freezer.
IMPORTANT: Due to the risk of anaerobic bacteria. fresh mushrooms,
onions, and garlic should never be vacuum packaged.
PREPARATION HINTS FOR POWDERY FOODS :
When vacuum packaging powdery items like flour, it’s best to use their
original packaging inside of the vacuum bags. Otherwise, the fine powder could
get sucked into the machine and cause enough damage to shorten the life of the
sealer.
PREPARATION HINTS FOR LIQUIDS :
Before you vacuum package liquid such as soup stock, pre-freeze them in a
casserole dish, loaf pan, or Ice cube tray until solid. Remove the frozen
liquid from the pan and vacuum package in the vacuum bags. You can then stack
it in the freezer. When you ro ready to use, just cut a corner of the bag
and place it in either a microwave dish or drop it into the water at a low
simmer below 170*F (75″C).
MAIN PARTS OF YOUR NEW VACUUM SEALER
A. DRY
Touch this button to vacuum and seal dry food.
B. MOIST
Touch this button to vacuum and seal moist food.
This function works for 30 seconds at a time to keep the machine from heating
up.
C. SEAL ONLY / CANCEL
Touch to create a seal (without vacuum)2. Touch to immediately stop the
current process (cancel function).
D. PULSE
Touch this button to start the vacuum pump. release the button and it
stops.
E. CANISTER ION & OFF
- Touch to make a vacuum in a canister.
- Touch and hold the Canister button to lock the digital control panel and once again unlock it.
F. PORT FOR VACUUMING CANISTER
- Insert one end of the accessory hose into this port, but the other end onto the canister port, and then touch the
- Canister button to make the canister vacuum fresh
G. LOCK
H. RUBBER SEALING STRIP
I. FOAM GASKETS (UP AND DOWN)
J. VACUUM CHAMBER
K. HEATING WIRE (COVERED BY TEFLON TAPE)|
L. CUTTER
HOW TO USE THE BAG CUTTER
In the back of the appliance is the bag cutter. This accessory easily lets you get an even and neat at Frayed, lopsided, or crooked edges could prevent the generation of vacuum and interfere with the sealing process.
-
Open the cutter bar. To do this, push the black handles at both Wes of the cutter bar to the rear of the appliance.
-
Insert the bag between the cutter bar and the base of the appliance. Then press the cutter bar in place again, until it clicks shut.
Push the slider of the cutting bar to the opposite end of the cutter Dar. -
Pull the bag out from under the cutter bar.
HOW TO MAKE CUSTOM-SIZED BAGS
-
Pull enough bag material to hold an item to be vacuum packaged, plus 2 inches. With the cutter, cut the desired bag length from the bag roll. Make sure to cut in a straight line. Plugin the power cord.
-
Open Place one end of the cut bag onto sealing strip. don’t worry If you accidentally place any material onto the gasket area.
-
Close the lid firmly by touching down firmly on both sides, check to make sure that the lid will not open.
If you hear a ‘click” on each side, then you have successfully locked the lid in place.
NOTE: The sealing strip will NOT work properly unless you lock the lid. Make sure that the lid has been locked on both sides for proper sealing. -
Now that the lid has been locked, touch the Seal Only button to create a custom-sized bag. The indicator light illuminates during the sealing process.
-
Once completed the indicator light will turn off, press the release buttons on both sides of the machine, it is now safe to take out the newly created bag.
-
The custom-sized bag is now ready for vacuum sealing.
CAUTION: Make sure you give the appliance time to cool down. Wait at
least 20 seconds between seals. Under very heavy usage, the appliance will
shut off automatically to prevent overheating. If it does.
wait 20 minutes to allow the appliance to cool off,
HOW TO VACUUM SEAL WITH THE VACUUM BAGS
- Place the item(s) to be sealed Into the pre-cut or custom-sized bag. Leave at least 2 Inches between the contents and the top of the bag to allow for bag contraction.
- Open the lid and place the open end of the bag down into the vacuum channel.
- Close the lid firmly by pressing down firmly on both sides, check to make sure that the lid will not open. If you hear a “click on each side, then you have successfully locked the lid in place.
- To begin the vacuum process, touch the Dry or Moist button depending on what food is being sealed. The unit will continue to vacuum and then seal once the air has been removed.
- Once the Indicator light has turned off, press the release buttons on both sides of the machine to release the bag.
NOTE: There is a 30 second stop on the condition of continuous working
for a moist vacuum.
HOW TO USE THE VACUUM SEALER WITH A CANISTER
NOTE: Canister Is not Included. The accessory hose may not fit all
canister lids.
-
Wipe canister cover and canister base and ensure they are clean and dry.
-
Place food Into the canister and leave at least one inch of space between food and cover,
-
Place cover onto the canister and insert one end of accessory hose into the port on the appliance.
Put the other end onto the canister port, pressing down firmly to ensure a tight fit. -
Close the lid by pressing down on both sides. If you hear a “click’ on each side, then you have successfully locked the lid In place.
-
To begin the vacuum process. touch the Canister button. The unit will continue to vacuum and then seal once air has been removed,
-
Once the Indicator light has turned off, it is safe to remove the accessory hose from the appliance and canister.
CARE & CLEANING
- Always unplug the unit before cleaning.
- Do not immerse in water.
- Do not use abrasives to dean the unit.
- Wipe the outer surface with a soft, damp cloth and soap.
- To clean the inside of the unit, wipe away any food or liquid with a paper towel.
- Dry all parts thoroughly before you plug in and operate the unit again.
- The vacuum chamber may trap liquids that were drawn from the bag. Use mild dishwashing soap and a warm, damp cloth to wipe away any liquids left behind liquid from the vacuum chamber. Dry thoroughly.
TROUBLESHOOTING
NOTHING HAPPENS WHEN I PRESS THE “VACUUM & SEAL” BUTTON:
-
Make sure the power cord is correctly plugged into the electrical outlet.
-
Make sure the power cord is not damaged in any way.
-
Make sure the electrical outlet is operative by plugging in another appliance.
If it’s not, please check the circuit breakers or fuses in your home. -
Make sure the bag is positioned correctly down in the vacuum chamber.
-
Press down on both sides of the lid and make sure it is locked in place.
-
Wait 25 minutes to allow the appliance to cool off, and then try using it again.
AIR IS NOT VACUUMED FROM THE BAG:
-
Check that there are no gaps, folds, wrinkles, or holes in the pre-sealed bags.
-
Check for loose, worn, or cracked Upper and Lower sealing gaskets.
-
Foods with high liquid contents may prevent the bag from sealing properly.
Cut the bag open and wipe the top inside of the bag and reseal. -
Check to see if the bag is properly inserted into the vacuum chamber.
-
Make sure you’ve placed the bag correctly.
When making a bag from a roll, make sure the end of the cut piece is on the sealing strip.
BAG MELTS:
-
The sealing strip may have been too hot during the sealing process. Allow the unit to cool for 20 seconds between uses. If the bag continues to melt, allow the unit to cool with the lid in the upright position for 25 minutes before using.
AIR HAS SEEPED BACK INTO THE VACUUMED BAG -
Check the seal of the bag. There may be a hole or wrinkle that is allowing air to reenter the bag. Carefully cut the bag open and re-seal it, or use an entirely new bag.
-
Make sure there is no moisture or liquid from the food present within the bag seal. You may need to cut open the bag and re-seal it, or use an entirely new bag. Partially freeze foods with excess liquids prior to vacuum sealing.
-
Make sure there are no food items with sharp edges that may have punctured the bag. If you find a puncture hole, seal the item in an entirely new bag.
-
Make sure no liquids were drawn to the sealing strip area.
-
Check for loose, worn, or cracked Upper and Lower sealing gaskets.
-
The moisture of foods with high liquid content will prevent the bag from sealing properly. Cut the bag open and wipe the top inside of the bag and reseal.
BAG WILL NOT SEAL:
- Check that there aren’t any gaps, folds, wrinkles, or holes in pre-sealed edges.
- The moisture of foods with high liquid content will prevent the bag from sealing properly. Cut bag open and wipe the top inside of the bag and reseal.
- Make sure you’ve placed the bag correctly. When making a bag from a roll, make sure the end of the cut piece is on the sealing strip.
- Make sure you’ve given the appliance time to cool down. Wait 20 seconds between seals.
ShopProSeal.com
@LiShopProSeal