Telaire Carbon Dioxide and Temperature Monitor Instructions
- June 7, 2024
- Telaire
Table of Contents
Telaire Carbon Dioxide and Temperature Monitor
Telaire CO 2 and Temperature Monitor
Applies to this Telaire CO 2 and Temperature Monitor
| Onset Part No. | Outputs | Telaire Part No. |
|---|---|---|
| TEL-7001 | 0-4V representing 0 to 4000 ppm CO2 | |
| 0-4V representing 0 to +40°C (+32 to +104°F) | 7001 |
This document provides instructions on connecting the Telaire CO2 and
Temperature
Monitor listed above to each of the following:
- FlexSmart™ Analog Module used with HOBO H22 series data loggers
- Analog Sensor Port/Module option used with HOBO U30 and RX3000 series loggers
- Voltage adapter cables used with the U12, UX120-006M, MX1104, and MX1105 data loggers and ZW series data nodes
It also lists configuration values used by HOBO software to configure the
logger for the monitor.
Note: For information on powering the monitor for long-term applications,
and other monitor details, refer to the documentation provided by GE Sensing.
Required
- Telaire CO2 and Temperature Monitor listed above
- Telaire Cable, Onset Part No. CABLE-2070 (not required for U12 or ZW series when recording CO2 only)
- H22, U12, U30, UX120-006M, MX1104, MX1105, or RX3000 data logger, or HOBO ZW data node
- FlexSmart Analog Module, S-FS-CVIA (for H22 series); Analog Sensor Port/Module option (for U30 and RX3000 series); voltage adapter, CABLE-ADAP5 or CABLE-CO2 (for U12, UX120-006M, MX1104, MX1105, or ZW series)
- HOBOware® software, version 2.2.1 or higher for H22 or U12; 2.4.0 or higher for U30 series; 3.6 or higher for UX120-006M; HOBOware Pro 3.0 or higher for ZW series
- HOBOconnect™ for MX1104 and MX1105
- HOBOlink® for RX3000 series data loggers
**Connecting the CO 2 and Temperature Monitor to the Analog Module or
Port
**
H22 Connection
U30 or RX3000 Connection (U30 Shown)
ZW, U12, UX120-006M, MX1104, and MX1105 Connection
CO 2 only
ZW, U12, UX120-006M, and MX1105 Connection
**CO 2 and Temperature
**
**Configuring the Data Logger for the CO 2 and Temperature Monitor using
HOBO Software**
Use the following recommended scaling values in the software:
Channel 1
Channel Name| Measurement Type| Raw Value 1| Raw Value
2| Raw Units| Scaled Value 1| Scaled Value 2| Scaled
Units
CO2| Voltage| 0| 4| V| 0| 4000| PPM
Channel 2
Channel Name| Measurement Type| Raw Value 1| Raw Value
2| Raw Units| Scaled Value 1| Scaled Value 2| Scaled
Units
Temperature| Voltage| 0| 4| V| 0
32| 40
104| C F
Refer to the software documentation for more details on setting up scaling.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>