hansgrohe Raindance Connect Showerpipe, Eco Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
hansgrohe Raindance Connect Showerpipe, Eco
Product Information
The Raindance Connect Showerpipe is a shower system that includes a showerhead, hose, and a hand shower. It is available in two models: 27164000 and 27421000. There is also an eco-model, 27166XXX. The product comes with safety instructions, assembly instructions, technical data, spare parts information, and cleaning instructions. The product is tested according to the valid norms and has a recommended operating pressure of 0.2 – 0.5 MPa.
Product Usage Instructions
- Before installation, read the safety instructions provided in the manual carefully.
- Flush the pipes according to the valid norms before installing the shower system.
- Do not use silicone containing acetic acid during installation.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The arm of the shower head is intended only to hold the shower head. Do not load it down with other objects!
- The product may not be used as a holding handle. A separate handle must be installed.
- The shower system may only be used for bathing, hygienic and body cleansing purposes.
- Children as well as adults with physical, mental and/or sensoric impairments must not use this shower system without proper supervision.
- Persons under the influence of alcohol or drugs are prohibited from using this shower system.Do not allow the streams of the shower touch sensitive body parts (such as your eyes). An adequate distance must be kept between the shower and you.
Assembly
Important! The fitting must be installed, flushed and tested after the
valid norms!
Important! Do not use silicone containing acetic acid!
- Where the contractor mounts the product, he should ensure that the entire area of the wall to which the mounting plate is to be fitted, is flat (no projecting joints or tiles sticking out), that the structure of the wall is suitable for the installation of the product and has no weak points. The enclosed screws and dowels are only suitable for concrete. For another wall cons-tructions the manufacturer’s indications of the dowel manufacturer have to be taken into account.
- If required, the bottom part of the pipe between the fixture and the shower head can be shortened with a fine-toothed saw.
- The mesh washer must be insert to protect the overhead shower against incoming dirt by pipework. Incoming dirt leads to defects or/and can damage parts of the shower; such caused faults voids all liabili-ty and guarantee claims.
Assembly corner fitting set
Adjustment
Technical Data (see page 31)
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,2 – 0,5 MPa
- Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Operation
Spare parts
Cleaning
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>