Thomann BOTEX 1 Channel Dimmer CT-110R User Manual

: June 6, 2024
: Thomann

Table of Contents

User manual
Safety instructions
Features
Operating elements
Connections
Using the product
Technical specifications
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**Thomann BOTEX 1 Channel Dimmer CT-110R User Manual

**

User manual

This manual contains important information on the safe operation of the product.
Read and follow the safety advice and instructions given. Retain the manual for future reference. If you pass the product on to others please include this manual.

Safety instructions

Intended use

This device is used as a one-channel dimmer control for inductive loads. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use.

Danger for children

Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts from the product. They could swallow the pieces and choke! Never let children unattended use electrical devices.

Danger to life due to electric shock
The electrical wiring may only be made by a qualified electrician.

Where to use the product

Never use the product

in conditions of extreme temperature or humidity
in extremely dusty or dirty areas
at locations where the unit can become wet

General handling

To prevent damage, never use force when handling the product.
Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use liquid cleaners such as benzene, thinners or flammable cleaning agents.

Features

Dimmer and Flash function
0 – 10 V control
Connections via terminals
Up to 5 devices can be interconnected

Operating elements

FUSE: Fuse holder
LED: shows the channel intensity
Slider: controls the intensity between 0 and full
FLASH: button for full output signal

Connections

To connect the device, screw open the housing.
The pre-punched holes on the back of the unit can be broken up and used to feed through the cables.
Connect the load to be controlled to the terminals ‘LOAD’.
If desired, connect an external control (0 – 10 V) to the ‘LINK UP’ terminals.
Make sure that the power cord to be used is not connected to the mains. Then connect the wires of the power cable to the terminals ‘AC IN’.
Orient yourself by the graphic on the right if you want to interconnect up to 5 devices.
Set the switch behind the ‘LINK UP’ terminals to the ‘LINK’ position to operate the unit in Slave mode. Set the switch to the ‘SEL’ position to operate the unit in Master mode.
Close the device housing and refit the screws.
Connect the power cord to the mains.

Using the product

Control the connected load with the slider. The LED indicates the current intensity.
Press the FLASH button for full output.
After use, unplug the power cord from the mains.

Technical specifications

Control principle: Leading edge phase control
Dimmer output: 0 – 6.3 A
Operating voltage: 230 V ~ 50 Hz
External control: 0 – 10 V
Fuse: 5 mm × 20 mm, 6.3 A, 250 V, fast acting
Max. ambient temperature: 35 °C
Dimensions (W × H × D): 44 × 133 × 135 mm
Weight: 0.55 kg

For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the notes and markings on the packaging.

This product is subject to the European Waste Electrical and Electronic Equipment Directive (WEEE) in its currently valid version. Do not dispose of your old device with your normal household waste. Dispose of this product through an approved waste disposal firm or through your local waste facility. Comply with the rules and regulations that apply in your country. If in doubt, consult your local waste disposal facility.

Thomann GmbH