POWER-TO-GO CP112-2 Outdoor Flame Speaker User Guide
- June 6, 2024
- Power-To-Go
Table of Contents
OUTDOOR
FLAME SPEAKER
PRODUCT OVERVIEW
CHARGING YOUR SPEAKER
The battery must be fully charged prior to use. It takes approximately 4 hours to fully charge your Speaker (from the depleted unit).
A Via AC Adapter/Wall Charger: Using the provided Micro USB cable, connect your Speaker (Micro USB port) to the AC Adapter (USEI port).
B Via Computer: Using the provided Micro USB cable, connect your Speaker (Micro Use port) to the computer/laptop (USB port).
**PAIRING THE SPEAKER
TO BLUETOOTH DEVICE**
Make sure the Bluetooth function is available on your cell phone. Specific palling procedures WI be different depending on &trent cel phone. For detailed information, please refer to your cell phone’s User Guide.
- After a successful pairing, devices will memorize each other. Therefore, no pairing IA be needed next time
- Keep the distance between the cell phone and the speaker within 3 feet ( for pairing only).
- Turn on the speaker by pressing the “Power On/Off” button
- The tone prompt will sound. The unit will automatically enter into pairing mode.
- Activate the Bluetooth function of the cell phone to search for Bluetooth devices. After finishing the search, select “A1 +” in the device list displayed.
- Your Al+ speaker is ready to use.
SPENCER CONTROLS
ON/OFF
Press and release the Power On/Off button
VOLUME
During a call of when listening to music
Volume +
Press and hold + Button.
Volume –
Press and hold – button.
MUSIC
Go to the next song
Long Press +
Go to the previous song
Long Press –
TF CARD MODE (automatic after inserting TF card)
Go to the next song | Go to the previous song | Play/Pause |
---|---|---|
Press + Button | Press – Button | Press Button |
PLAY/PAUSE
Press to play/pause the music.
TWS MODE
- Turn off the Bluetooth mode on your mobile device,
- Turn on the speakers by pressing the”Power On/Off” button
- On either speaker, press and hold the “LED Flame On/Off” button for 3-5 seconds, and wait until you hear a “ding-dong” confirmation tone. The speakers are now connected, and you can connect your Bluetooth device.
LED FLAME
To use the LED flame function, press and release the LED Flame On/Off button once. The lamp will turn on to the dimmest setting. There are 3 brightness levels; press and release to change the brightness.
IMPORTANT SAFEGUARDS
- Keep the speaker away from any source of heat.
- Always adjust the speaker volume to a suitable level to avoid hearing damage or damage to the unit.
- If not using the speaker for a long period of time, keep the internal battery charged (charge once every 3 months). This will extend the life of your lithium battery.
SPECIFICATIONS
- Frequency: 50 Hz-20KHZ
- Battery: 1500 mAh Li-Ion
- Distance: 33 ft (10m)
- Charging time: 4 Hours
- Playing tire: 10 Hours
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>